What was found in ZIP 14001
The highest level seen across the suppliers serving this ZIP, the EPA limit for each, and where the figure comes from.
| Contaminant | Level vs EPA limit | Suppliers | Source |
|---|---|---|---|
| Fluoride | 930 µg/L 23% of the EPA limit 4000 µg/L | 2/3 | SYR4 |
| Nitrate | 540 µg/L 5.4% of the EPA limit 10000 µg/L | 2/3 | SYR4 |
| Nitrate-Nitrite | 390 µg/L 3.9% of the EPA limit 10000 µg/L | 1/3 | SYR4 |
| TTHM | 93 µg/L 116% of the EPA limit, in the worst sample — 80 µg/L | 3/3 | SYR4 |
| Chloroform | 71 µg/L No EPA limit set | 3/3 | SYR4 |
| Total Haloacetic Acids (HAA5) | 68.8 µg/L 115% of the EPA limit, in the worst sample — 60 µg/L | 3/3 | SYR4 |
| Dichloroacetic Acid | 40.2 µg/L No EPA limit set | 3/3 | SYR4 |
| Barium | 27 µg/L 1.4% of the EPA limit 2000 µg/L | 2/3 | SYR4 |
| Trichloroacetic Acid | 26 µg/L No EPA limit set | 3/3 | SYR4 |
| Bromodichloromethane | 21.9 µg/L No EPA limit set | 3/3 | SYR4 |
| Monobromoacetic Acid | 14.5 µg/L No EPA limit set | 3/3 | SYR4 |
| Dibromochloromethane | 14 µg/L No EPA limit set | 3/3 | SYR4 |
| Lithium | 12.1 µg/L No EPA limit set | 1/3 | UCMR-5 |
| Monochloroacetic Acid | 9.3 µg/L No EPA limit set | 3/3 | SYR4 |
| Dibromoacetic Acid | 4.9 µg/L No EPA limit set | 3/3 | SYR4 |
| Arsenic | 2.6 µg/L 26% of the EPA limit 10 µg/L | 2/3 | SYR4 |
| Bromoform | 1.8 µg/L No EPA limit set | 3/3 | SYR4 |
| Chromium | 1.3 µg/L 1.3% of the EPA limit 100 µg/L | 1/3 | SYR4 |
| Combined Radium (-226 And -228) | 1.25 pCi/L 25% of the EPA limit 5 pCi/L | 1/3 | SYR4 |
| 1,2-Dichloroethane | 1.2 µg/L 24% of the EPA limit 5 µg/L | 1/3 | SYR4 |
| Selenium | 1.1 µg/L 2.2% of the EPA limit 50 µg/L | 1/3 | SYR4 |
| Antimony, Total | 0.7000 µg/L 12% of the EPA limit 6 µg/L | 1/3 | SYR4 |
| Atrazine | 0.0740 µg/L 2.5% of the EPA limit 3 µg/L | 2/3 | SYR4 |
| Mercury | 0.0660 µg/L 3.3% of the EPA limit 2 µg/L | 1/3 | SYR4 |
| Thallium, Total | 0.0300 µg/L 1.5% of the EPA limit 2 µg/L | 1/3 | SYR4 |
| Cadmium | 0.0200 µg/L 0.4% of the EPA limit 5 µg/L | 1/3 | SYR4 |
| Lead | 0.0060 mg/L 40% of the EPA limit 0.0150 mg/L | 3/3 | LCR |
Each bar shows the measured level as a share of the EPA limit: green is
well under, amber is close to it, red is over. For lead and copper the
limit applies to exactly the 90th-percentile figure shown, so red there
means a real exceedance. For everything else the limit applies to a
running annual average while the figure is the single worst sample on
record — over 100% is worth reading, but is not by itself a violation.
Formal violations are listed separately.
Water suppliers serving ZIP 14001
| Supplier | State | Population served |
|---|---|---|
| MCWA | NY | 525,262 |
| ECWA DIRECT | NY | 313,380 |
| ROYALTON TOWNWIDE WATER DIST. | NY | 7,710 |
Frequently asked questions about ZIP 14001 tap water
Is the tap water in ZIP 14001 safe to drink?
EPA testing detected 27 contaminants across the water suppliers serving ZIP 14001. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and your utility's annual Consumer Confidence Report for the official status.
Which water suppliers serve ZIP 14001?
3 public water suppliers report EPA drinking-water monitoring for ZIP 14001. Each is listed above with its population served.
What contaminants are in ZIP 14001's water?
EPA monitoring detected Fluoride, Nitrate, Nitrate-Nitrite, TTHM, Chloroform, and others across this ZIP's suppliers. The full list with levels and sources is above.