What was found in ZIP 15010
The highest level seen across the suppliers serving this ZIP, the EPA limit for each, and where the figure comes from.
| Contaminant | Level vs EPA limit | Suppliers | Source |
|---|---|---|---|
| Nitrate | 1890 µg/L 19% of the EPA limit 10000 µg/L | 1/1 | SYR4 |
| Copper | 1030 µg/L 79% of the EPA limit 1300 µg/L | 1/1 | SYR4 |
| Fluoride | 740 µg/L 19% of the EPA limit 4000 µg/L | 1/1 | SYR4 |
| TTHM | 96.7 µg/L 121% of the EPA limit, in the worst sample — 80 µg/L | 1/1 | SYR4 |
| Dibromochloromethane | 92 µg/L No EPA limit set | 1/1 | SYR4 |
| Total Haloacetic Acids (HAA5) | 81.2 µg/L 135% of the EPA limit, in the worst sample — 60 µg/L | 1/1 | SYR4 |
| Bromoform | 65 µg/L No EPA limit set | 1/1 | SYR4 |
| Chloroform | 52.5 µg/L No EPA limit set | 1/1 | SYR4 |
| Barium | 52 µg/L 2.6% of the EPA limit 2000 µg/L | 1/1 | SYR4 |
| Dichloroacetic Acid | 37.3 µg/L No EPA limit set | 1/1 | SYR4 |
| Bromodichloromethane | 32 µg/L No EPA limit set | 1/1 | SYR4 |
| Xylenes, Total | 24.3 µg/L 0.2% of the EPA limit 10000 µg/L | 1/1 | SYR4 |
| Trichloroacetic Acid | 23.4 µg/L No EPA limit set | 1/1 | SYR4 |
| Dibromoacetic Acid | 17 µg/L No EPA limit set | 1/1 | SYR4 |
| Monochloroacetic Acid | 11.6 µg/L No EPA limit set | 1/1 | SYR4 |
| Cyanide | 8 µg/L 4% of the EPA limit 200 µg/L | 1/1 | SYR4 |
| Monobromoacetic Acid | 7.09 µg/L No EPA limit set | 1/1 | SYR4 |
| Lead | 6 µg/L 40% of the EPA limit 15 µg/L | 1/1 | SYR4 |
| Ethylbenzene | 4.1 µg/L 0.6% of the EPA limit 700 µg/L | 1/1 | SYR4 |
| Chromium | 2.33 µg/L 2.3% of the EPA limit 100 µg/L | 1/1 | SYR4 |
| Dalapon | 1.47 µg/L 0.7% of the EPA limit 200 µg/L | 1/1 | SYR4 |
| Arsenic | 1 µg/L 10% of the EPA limit 10 µg/L | 1/1 | SYR4 |
| Atrazine | 0.3000 µg/L 10% of the EPA limit 3 µg/L | 1/1 | SYR4 |
| Benzo(A)Pyrene | 0.1100 µg/L 55% of the EPA limit 0.2000 µg/L | 1/1 | SYR4 |
| PFBS | 0.0369 µg/L No EPA limit set | 1/1 | UCMR-5 |
| Pfba | 0.0083 µg/L No EPA limit set | 1/1 | UCMR-5 |
| Pfpea | 0.0078 µg/L No EPA limit set | 1/1 | UCMR-5 |
| Pfhxa | 0.0077 µg/L No EPA limit set | 1/1 | UCMR-5 |
| PFOA | 0.0054 µg/L No EPA limit set | 1/1 | UCMR-5 |
| PFOS | 0.0040 µg/L No EPA limit set | 1/1 | UCMR-5 |
| Lead | 0.0013 mg/L 8.7% of the EPA limit 0.0150 mg/L | 1/1 | LCR |
Each bar shows the measured level as a share of the EPA limit: green is
well under, amber is close to it, red is over. For lead and copper the
limit applies to exactly the 90th-percentile figure shown, so red there
means a real exceedance. For everything else the limit applies to a
running annual average while the figure is the single worst sample on
record — over 100% is worth reading, but is not by itself a violation.
Formal violations are listed separately.
Water suppliers serving ZIP 15010
| Supplier | State | Population served |
|---|---|---|
| BEAVER FALLS MUNI AUTH | PA | 49,500 |
Frequently asked questions about ZIP 15010 tap water
Is the tap water in ZIP 15010 safe to drink?
EPA testing detected 31 contaminants across the water suppliers serving ZIP 15010. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and your utility's annual Consumer Confidence Report for the official status.
Which water suppliers serve ZIP 15010?
1 public water supplier report EPA drinking-water monitoring for ZIP 15010. Each is listed above with its population served.
What contaminants are in ZIP 15010's water?
EPA monitoring detected Nitrate, Copper, Fluoride, TTHM, Dibromochloromethane, and others across this ZIP's suppliers. The full list with levels and sources is above.