← Washington

Tap water quality report

West Ridge Water

EPA monitoring tested this supplier for 55 contaminants and detected 12. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

55
contaminants tested
12
detected
275
people served
1
health-based violations
Water source
Ground water
Ownership
Private
Counties served
Island

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

1
health-based violations
5
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 2005-07-01 → 2005-07-31
MR Monitoring Resolved 2022-01-01 → 2022-12-31
MR Monitoring Resolved 2020-01-01 → 2022-12-31
MR Monitoring Resolved 2019-01-01
MR Monitoring Archived 1979-10-01 → 1979-10-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.00070 mg/L 4.7%
of the EPA limit 0.0150 mg/L
14/14 LCR 2025
Bromodichloromethane
1.76 µg/L
No EPA limit set
worst single sample: 1.8 µg/L
5/5 SYR4 2013–2019
Bromoform
11.64 µg/L
No EPA limit set
worst single sample: 12.8 µg/L
5/5 SYR4 2013–2019
Dibromochloromethane
5.3 µg/L
No EPA limit set
worst single sample: 5.4 µg/L
5/5 SYR4 2013–2019
TTHM
18.4 µg/L 23%
of the EPA limit 80 µg/L
worst single sample: 19.5 µg/L
5/5 SYR4 2013–2019
Dibromoacetic Acid
1.88 µg/L
No EPA limit set
worst single sample: 1.9 µg/L
3/3 SYR4 2013–2017
Total Haloacetic Acids (HAA5)
3.33 µg/L 5.6%
of the EPA limit 60 µg/L
worst single sample: 3.4 µg/L
3/3 SYR4 2013–2017
Arsenic
9.49 µg/L 95%
of the EPA limit 10 µg/L
worst single sample: 9.6 µg/L
2/2 SYR4 2012–2017
Cadmium
1.7 µg/L 34%
of the EPA limit 5 µg/L
1/1 SYR4 2012
Lead
2.1 µg/L 14%
of the EPA limit 15 µg/L
1/1 SYR4 2012
Monobromoacetic Acid
1 µg/L
No EPA limit set
1/3 SYR4 2013–2017
Trichloroacetic Acid
1.5 µg/L
No EPA limit set
1/3 SYR4 2013–2017
43 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalBariumBenzeneBeryllium, TotalChlorobenzeneCopperCyanideCarbon TetrachlorideChloroformChromiumDichloromethaneDalaponDichloroacetic AcidDinosebEthylbenzeneFluorideMercuryMonochloroacetic AcidNitrateNitrate-NitriteNitritePentachlorophenolPicloramSeleniumStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
Joanne Skaar

Frequently asked questions about West Ridge Water

Is West Ridge Water tap water safe to drink?

EPA monitoring detected 12 contaminants in West Ridge Water's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in West Ridge Water's water?

EPA monitoring detected Lead, Bromodichloromethane, Bromoform, Dibromochloromethane, TTHM, and others. The full list with the level and data source for each is above.

How many people does West Ridge Water serve?

West Ridge Water reports serving 275 people in Washington, per its EPA record.

Has West Ridge Water had any water quality violations?

The EPA has 5 violations on file for West Ridge Water, of which 1 is health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.