Tap WaterIndex

← Washington

Tap water quality report

Skagit Co Pud - Potlatch Beach

EPA monitoring tested this supplier for 13 contaminants and detected 7. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

13
contaminants tested
7
detected
75
people served
9
health-based violations
Washington rankingsLead in WashingtonPFAS in Washington
Water source
Surface water
Ownership
Local government
Counties served
Skagit

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

9
health-based violations
24
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 1996-10-01 → 1996-10-31
MCL Health-based Archived 1996-10-01 → 1996-10-31
MCL Health-based Archived 1996-10-01 → 1996-10-31
MCL Health-based Archived 1996-06-01 → 1996-06-30
MCL Health-based Archived 1992-12-01 → 1992-12-31
MCL Health-based Archived 1992-11-01 → 1992-11-30
MCL Health-based Archived 1992-06-01 → 1992-06-30
MCL Health-based Archived 1992-06-01 → 1992-06-30
MCL Health-based Archived 1992-06-01 → 1992-06-30
Other Monitoring Resolved 2014-07-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the single worst sample on record — over 100% is worth reading, but is not by itself a violation. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.0021 mg/L 14%
of the EPA limit 0.0150 mg/L
 10/10 LCR 2023
Nitrate
2870 µg/L 29%
of the EPA limit 10000 µg/L
 4/4 SYR4 2012–2013
Bromoform
6.4 µg/L
No EPA limit set
 2/2 SYR4 2014–2017
Dibromoacetic Acid
2 µg/L
No EPA limit set
 2/2 SYR4 2014–2017
TTHM
6.4 µg/L 8%
of the EPA limit 80 µg/L
 2/2 SYR4 2014–2017
Total Haloacetic Acids (HAA5)
2 µg/L 3.3%
of the EPA limit 60 µg/L
 2/2 SYR4 2014–2017
Dibromochloromethane
1.2 µg/L
No EPA limit set
 1/2 SYR4 2014–2017
6 contaminants tested, none detected
BromodichloromethaneChloroformDichloroacetic AcidMonobromoacetic AcidMonochloroacetic AcidTrichloroacetic Acid

Utility contact

Contact
Michael Fox

Frequently asked questions about Skagit Co Pud - Potlatch Beach

Is Skagit Co Pud - Potlatch Beach tap water safe to drink?

EPA monitoring detected 7 contaminants in Skagit Co Pud - Potlatch Beach's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Skagit Co Pud - Potlatch Beach's water?

EPA monitoring detected Lead, Nitrate, Bromoform, Dibromoacetic Acid, TTHM, and others. The full list with the level and data source for each is above.

How many people does Skagit Co Pud - Potlatch Beach serve?

Skagit Co Pud - Potlatch Beach reports serving 75 people in Washington, per its EPA record.

Has Skagit Co Pud - Potlatch Beach had any water quality violations?

The EPA has 24 violations on file for Skagit Co Pud - Potlatch Beach, of which 9 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.