Tap WaterIndex

← Washington

Tap water quality report

Flauras Acres Propertyowner

EPA monitoring tested this supplier for 50 contaminants and detected 4. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

50
contaminants tested
4
detected
150
people served
1
health-based violations
Washington rankingsLead in WashingtonPFAS in Washington
Water source
Ground water
Ownership
Private
Counties served
Clallam

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

1
health-based violations
33
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 1993-01-01 → 1993-01-31
Other Monitoring Resolved 2025-07-01
MR Monitoring Resolved 2006-01-01
MR Monitoring Resolved 2006-01-01
MR Monitoring Resolved 2006-01-01
MR Monitoring Resolved 2006-01-01
MR Monitoring Resolved 2006-01-01
MR Monitoring Resolved 2006-01-01
MR Monitoring Resolved 2006-01-01
MR Monitoring Resolved 2006-01-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
2080 µg/L 21%
of the EPA limit 10000 µg/L
 20/20 SYR4 2012–2019
Lead
0.0015 mg/L 10%
of the EPA limit 0.0150 mg/L
 10/10 LCR 2024
Arsenic
2.2 µg/L 22%
of the EPA limit 10 µg/L
 1/1 SYR4 2016
Nitrate-Nitrite
1970 µg/L 20%
of the EPA limit 10000 µg/L
 1/1 SYR4 2016
46 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalBariumBenzeneBeryllium, TotalBromodichloromethaneBromoformChlorobenzeneCopperCyanideCadmiumCarbon TetrachlorideChloroformChromiumDichloromethaneDalaponDibromochloromethaneDinosebEthylene DibromideEthylbenzeneFluorideLeadMercuryNitritePentachlorophenolPicloramSeleniumStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
Dale Metzger

Frequently asked questions about Flauras Acres Propertyowner

Is Flauras Acres Propertyowner tap water safe to drink?

EPA monitoring detected 4 contaminants in Flauras Acres Propertyowner's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Flauras Acres Propertyowner's water?

EPA monitoring detected Nitrate, Lead, Arsenic, Nitrate-Nitrite. The full list with the level and data source for each is above.

How many people does Flauras Acres Propertyowner serve?

Flauras Acres Propertyowner reports serving 150 people in Washington, per its EPA record.

Has Flauras Acres Propertyowner had any water quality violations?

The EPA has 33 violations on file for Flauras Acres Propertyowner, of which 1 is health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.