← Washington

Tap water quality report

Brandt Point

EPA monitoring tested this supplier for 57 contaminants and detected 16. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

57
contaminants tested
16
detected
32
people served
1
health-based violations
Water source
Ground water
Ownership
Private
Counties served
Clallam

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

1
health-based violations
195
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 2005-03-01 → 2005-03-31
Other Monitoring Resolved 2025-07-01
MR Monitoring Resolved 2014-07-01 → 2014-09-30
MR Monitoring Resolved 2014-07-01 → 2014-09-30
MR Monitoring Resolved 2014-07-01 → 2014-09-30
MR Monitoring Resolved 2014-07-01 → 2014-09-30
MR Monitoring Resolved 2014-07-01 → 2014-09-30
MR Monitoring Resolved 2014-07-01 → 2014-09-30
MR Monitoring Resolved 2014-07-01 → 2014-09-30
MR Monitoring Resolved 2014-07-01 → 2014-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
11/11 LCR 2023
Chloroform
11.56 µg/L
No EPA limit set
worst single sample: 13.3 µg/L
7/18 SYR4 2012–2019
TTHM
15.93 µg/L 20%
of the EPA limit 80 µg/L
worst single sample: 18.3 µg/L
7/7 SYR4 2012–2017
Bromodichloromethane
3.6 µg/L
No EPA limit set
worst single sample: 4 µg/L
6/20 SYR4 2012–2019
Toluene
112.42 µg/L 11%
of the EPA limit 1000 µg/L
worst single sample: 124.5 µg/L
5/15 SYR4 2012–2019
Dibromochloromethane
0.9600 µg/L
No EPA limit set
worst single sample: 1 µg/L
3/20 SYR4 2012–2019
Dichloroacetic Acid
6.47 µg/L
No EPA limit set
worst single sample: 6.8 µg/L
3/4 SYR4 2013–2018
Total Haloacetic Acids (HAA5)
13.06 µg/L 22%
of the EPA limit 60 µg/L
worst single sample: 14 µg/L
3/4 SYR4 2013–2018
Xylenes, Total
1.08 µg/L 0%
of the EPA limit 10000 µg/L
worst single sample: 1.1 µg/L
3/15 SYR4 2012–2019
Arsenic
2.98 µg/L 30%
of the EPA limit 10 µg/L
worst single sample: 3 µg/L
2/3 SYR4 2012–2019
Ethylbenzene
0.3905 µg/L 0.1%
of the EPA limit 700 µg/L
worst single sample: 0.4000 µg/L
2/15 SYR4 2012–2019
Nitrate
140 µg/L 1.4%
of the EPA limit 10000 µg/L
2/32 SYR4 2012–2019
Trichloroacetic Acid
6.895 µg/L
No EPA limit set
worst single sample: 7.2 µg/L
2/4 SYR4 2013–2018
Benzene
0.3000 µg/L 6%
of the EPA limit 5 µg/L
1/15 SYR4 2012–2019
Nitrate-Nitrite
140 µg/L 1.4%
of the EPA limit 10000 µg/L
1/3 SYR4 2012–2019
Styrene
5.9 µg/L 5.9%
of the EPA limit 100 µg/L
1/15 SYR4 2012–2019
41 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalBariumBeryllium, TotalBromoformChlorobenzeneCopperCyanideCadmiumCarbon TetrachlorideChromiumDichloromethaneDalaponDibromoacetic AcidDinosebEthylene DibromideFluorideLeadMercuryMonobromoacetic AcidMonochloroacetic AcidNitritePentachlorophenolPicloramSeleniumTetrachloroethyleneThallium, TotalTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
Dale Metzger

Frequently asked questions about Brandt Point

Is Brandt Point tap water safe to drink?

EPA monitoring detected 16 contaminants in Brandt Point's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Brandt Point's water?

EPA monitoring detected Lead, Chloroform, TTHM, Bromodichloromethane, Toluene, and others. The full list with the level and data source for each is above.

How many people does Brandt Point serve?

Brandt Point reports serving 32 people in Washington, per its EPA record.

Has Brandt Point had any water quality violations?

The EPA has 195 violations on file for Brandt Point, of which 1 is health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.