Tap WaterIndex

← Washington

Tap water quality report

Burman Acres Water

EPA monitoring tested this supplier for 66 contaminants and detected 8. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

66
contaminants tested
8
detected
92
people served
1
health-based violations
Washington rankingsLead in WashingtonPFAS in Washington
Water source
Ground water
Ownership
Private
Counties served
Yakima

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

1
health-based violations
46
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2011-01-01 → 2011-04-30
Other Monitoring Resolved 2016-07-01
MR Monitoring Resolved 2014-01-01 → 2016-12-31
MR Monitoring Resolved 2014-01-01 → 2016-12-31
MR Monitoring Resolved 2014-01-01 → 2016-12-31
MR Monitoring Resolved 2014-01-01 → 2016-12-31
MR Monitoring Resolved 2014-01-01 → 2016-12-31
MR Monitoring Resolved 2014-01-01 → 2016-12-31
MR Monitoring Resolved 2014-01-01 → 2016-12-31
MR Monitoring Resolved 2014-01-01 → 2016-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the single worst sample on record — over 100% is worth reading, but is not by itself a violation. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
820 µg/L 8.2%
of the EPA limit 10000 µg/L
 16/26 SYR4 2012–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 12/12 LCR 2024
Arsenic
6.3 µg/L 63%
of the EPA limit 10 µg/L
 4/4 SYR4 2013–2019
Fluoride
720 µg/L 18%
of the EPA limit 4000 µg/L
 3/3 SYR4 2013–2018
Nitrate-Nitrite
820 µg/L 8.2%
of the EPA limit 10000 µg/L
 3/6 SYR4 2013–2019
Lead
2 µg/L 13%
of the EPA limit 15 µg/L
 2/4 SYR4 2013–2019
Barium
1532 µg/L 77%
of the EPA limit 2000 µg/L
 1/3 SYR4 2013–2018
Selenium
2.7 µg/L 5.4%
of the EPA limit 50 µg/L
 1/4 SYR4 2013–2019
58 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalBromodichloromethaneBromoformChlorobenzeneCopperCyanideCadmiumCarbon TetrachlorideChlordaneChloroformChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromochloromethaneDinosebEthylene DibromideEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorNitritePentachlorophenolPicloramSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
Bennett Osborne

Frequently asked questions about Burman Acres Water

Is Burman Acres Water tap water safe to drink?

EPA monitoring detected 8 contaminants in Burman Acres Water's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Burman Acres Water's water?

EPA monitoring detected Nitrate, Lead, Arsenic, Fluoride, Nitrate-Nitrite, and others. The full list with the level and data source for each is above.

How many people does Burman Acres Water serve?

Burman Acres Water reports serving 92 people in Washington, per its EPA record.

Has Burman Acres Water had any water quality violations?

The EPA has 46 violations on file for Burman Acres Water, of which 1 is health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.