← Washington

Tap water quality report

The Buttes

EPA monitoring tested this supplier for 71 contaminants and detected 8. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

71
contaminants tested
8
detected
973
people served
0
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Pierce

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
2
violations on file
0
still open
ViolationTypeStatusPeriod
Other Monitoring Resolved 2015-07-01
Other Monitoring Resolved 2013-07-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the single worst sample on record — over 100% is worth reading, but is not by itself a violation. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Chloroform
21 µg/L
No EPA limit set
11/11 SYR4 2013–2019
TTHM
26.3 µg/L 33%
of the EPA limit 80 µg/L
11/11 SYR4 2013–2019
Bromodichloromethane
4.88 µg/L
No EPA limit set
10/11 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
17.3 µg/L 29%
of the EPA limit 60 µg/L
10/10 SYR4 2013–2019
Trichloroacetic Acid
11.1 µg/L
No EPA limit set
10/10 SYR4 2013–2019
Dichloroacetic Acid
6.2 µg/L
No EPA limit set
9/10 SYR4 2013–2019
Lead
0.0027 mg/L 18%
of the EPA limit 0.0150 mg/L
9/9 LCR 2023
Dibromochloromethane
1.19 µg/L
No EPA limit set
3/10 SYR4 2013–2019
63 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBhc-GammaBariumBenzeneBenzo(A)PyreneBeryllium, TotalBromoformChlorobenzeneCopperCyanideCadmiumCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDinosebEndrinEthylbenzeneFluorideHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoLeadMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNitrateNitrate-NitriteNitritePentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
Sean Vance

Frequently asked questions about The Buttes

Is The Buttes tap water safe to drink?

EPA monitoring detected 8 contaminants in The Buttes's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in The Buttes's water?

EPA monitoring detected Chloroform, TTHM, Bromodichloromethane, Total Haloacetic Acids (HAA5), Trichloroacetic Acid, and others. The full list with the level and data source for each is above.

How many people does The Buttes serve?

The Buttes reports serving 973 people in Washington, per its EPA record.

Has The Buttes had any water quality violations?

The EPA has 2 violations on file for The Buttes, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.