Tap WaterIndex

← PQ

Tap water quality report

Beebe Plain Water

EPA monitoring tested this supplier for 14 contaminants and detected 7. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

14
contaminants tested
7
detected
142
people served
113
health-based violations
PQ rankingsLead in PQPFAS in PQ
Water source
GWP
Ownership
Private
Counties served
Orleans

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

113
health-based violations
144
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2014-10-01 → 2014-12-31
MCL Health-based Resolved 2014-10-01 → 2014-12-31
MCL Health-based Resolved 2014-10-01 → 2014-12-31
MCL Health-based Resolved 2014-10-01 → 2014-12-31
MCL Health-based Resolved 2014-10-01 → 2014-12-31
MCL Health-based Resolved 2014-07-01 → 2014-09-30
MCL Health-based Resolved 2014-07-01 → 2014-09-30
MCL Health-based Resolved 2014-07-01 → 2014-09-30
MCL Health-based Resolved 2014-07-01 → 2014-09-30
MCL Health-based Resolved 2014-07-01 → 2014-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the single worst sample on record — over 100% is worth reading, but is not by itself a violation. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.0030 mg/L 20%
of the EPA limit 0.0150 mg/L
 11/11 LCR 2015
Copper
370 µg/L 28%
of the EPA limit 1300 µg/L
 9/11 SYR4 2012–2015
Chloroform
1 µg/L
No EPA limit set
 4/11 SYR4 2012–2014
Lead
5 µg/L 33%
of the EPA limit 15 µg/L
 4/11 SYR4 2012–2015
Bromodichloromethane
1 µg/L
No EPA limit set
 2/11 SYR4 2012–2014
Dibromochloromethane
1 µg/L
No EPA limit set
 1/11 SYR4 2012–2014
TTHM
3 µg/L 3.8%
of the EPA limit 80 µg/L
 1/2 SYR4 2013–2014
7 contaminants tested, none detected
BromoformDibromoacetic AcidDichloroacetic AcidMonobromoacetic AcidMonochloroacetic AcidTotal Haloacetic Acids (HAA5)Trichloroacetic Acid

Utility contact

Contact
DUHAMEL, KARINE
Phone
819-876-7181
Email
k.duhamel@stanstead.ca

Frequently asked questions about Beebe Plain Water

Is Beebe Plain Water tap water safe to drink?

EPA monitoring detected 7 contaminants in Beebe Plain Water's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Beebe Plain Water's water?

EPA monitoring detected Lead, Copper, Chloroform, Lead, Bromodichloromethane, and others. The full list with the level and data source for each is above.

How many people does Beebe Plain Water serve?

Beebe Plain Water reports serving 142 people in PQ, per its EPA record.

Has Beebe Plain Water had any water quality violations?

The EPA has 144 violations on file for Beebe Plain Water, of which 113 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.