Tap WaterIndex

← Virginia

Tap water quality report

Belview

EPA monitoring tested this supplier for 12 contaminants and detected 10. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

12
contaminants tested
10
detected
1,034
people served
0
health-based violations
Virginia rankingsLead in VirginiaPFAS in Virginia
Water source
SWP
Ownership
Local government
Counties served
Montgomery

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
4
violations on file
0
still open
ViolationTypeStatusPeriod
Other Monitoring Resolved 2024-10-02
Other Monitoring Resolved 2024-10-02
Other Monitoring Resolved 2014-07-01
Other Monitoring Resolved 2014-07-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the single worst sample on record — over 100% is worth reading, but is not by itself a violation. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Total Haloacetic Acids (HAA5)
83.1 µg/L 139%
of the EPA limit, in the worst sample — 60 µg/L
 33/33 SYR4 2012–2019
Bromodichloromethane
3860 µg/L
No EPA limit set
 32/32 SYR4 2012–2019
Chloroform
74.1 µg/L
No EPA limit set
 32/32 SYR4 2012–2019
Dichloroacetic Acid
37.8 µg/L
No EPA limit set
 32/32 SYR4 2012–2019
TTHM
80.3 µg/L 100%
of the EPA limit, in the worst sample — 80 µg/L
 32/32 SYR4 2012–2019
Trichloroacetic Acid
41.7 µg/L
No EPA limit set
 32/32 SYR4 2012–2019
Monochloroacetic Acid
16.4 µg/L
No EPA limit set
 25/32 SYR4 2012–2019
Dibromochloromethane
0.9900 µg/L
No EPA limit set
 15/32 SYR4 2012–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 7/7 LCR 2026
Monobromoacetic Acid
10.6 µg/L
No EPA limit set
 6/32 SYR4 2012–2019
2 contaminants tested, none detected
BromoformDibromoacetic Acid

Utility contact

Contact
POFF, BRIAN
Email
poffbe@montgomerycountyva.gov

Frequently asked questions about Belview

Is Belview tap water safe to drink?

EPA monitoring detected 10 contaminants in Belview's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Belview's water?

EPA monitoring detected Total Haloacetic Acids (HAA5), Bromodichloromethane, Chloroform, Dichloroacetic Acid, TTHM, and others. The full list with the level and data source for each is above.

How many people does Belview serve?

Belview reports serving 1,034 people in Virginia, per its EPA record.

Has Belview had any water quality violations?

The EPA has 4 violations on file for Belview, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.