Is Castledale Tap Water Safe? Quality Report

Water source: Surface water
Ownership: Local government
Counties served: Emery

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

health-based violations

139

violations on file

still open

Violation	Type	Status	Period
Other	Monitoring	Resolved	2017-10-01
Other	Monitoring	Resolved	2017-10-01
Other	Monitoring	Resolved	2017-10-01
MR	Monitoring	Resolved	2009-01-01 → 2009-12-31
MR	Monitoring	Resolved	2009-01-01 → 2009-12-31
MR	Monitoring	Resolved	2009-01-01 → 2009-12-31
MR	Monitoring	Resolved	2009-01-01 → 2009-12-31
MR	Monitoring	Resolved	2009-01-01 → 2009-12-31
MR	Monitoring	Resolved	2009-01-01 → 2009-12-31
MR	Monitoring	Resolved	2009-01-01 → 2009-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.

Contaminant	Level vs EPA limit	Detection rate	Source	Period
TTHM	59.225 µg/L 74% of the EPA limit 80 µg/L worst single sample: 100.7 µg/L	60/64	SYR4	2012–2019
Total Haloacetic Acids (HAA5)	38.415 µg/L 64% of the EPA limit 60 µg/L worst single sample: 48.7 µg/L	60/64	SYR4	2012–2019
Dichloroacetic Acid	17.69 µg/L No EPA limit set worst single sample: 24 µg/L	54/58	SYR4	2012–2019
Trichloroacetic Acid	15.595 µg/L No EPA limit set worst single sample: 21.4 µg/L	54/58	SYR4	2012–2019
Bromodichloromethane	5.98 µg/L No EPA limit set worst single sample: 6.4 µg/L	53/57	SYR4	2012–2019
Chloroform	61.36 µg/L No EPA limit set worst single sample: 96.8 µg/L	53/57	SYR4	2012–2019
Copper	560.66 µg/L 43% of the EPA limit 1300 µg/L worst single sample: 620 µg/L	30/30	SYR4	2013–2019
Lead	5.43 µg/L 36% of the EPA limit 15 µg/L worst single sample: 5.8 µg/L	28/30	SYR4	2013–2019
Lead	0.0027 mg/L 18% of the EPA limit 0.0150 mg/L	20/20	LCR	2025
Dibromochloromethane	1.18 µg/L No EPA limit set worst single sample: 1.3 µg/L	13/57	SYR4	2012–2019
Monochloroacetic Acid	26.8 µg/L No EPA limit set	1/58	SYR4	2012–2019

3 contaminants tested, none detected

BromoformDibromoacetic AcidMonobromoacetic Acid

Utility contact

Contact: SHARP, JACOB
Phone: 435-381-5333
Email: JSHARP@ETV.NET

Frequently asked questions about Castledale

Is Castledale tap water safe to drink?

EPA monitoring detected 11 contaminants in Castledale's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Castledale's water?

EPA monitoring detected TTHM, Total Haloacetic Acids (HAA5), Dichloroacetic Acid, Trichloroacetic Acid, Bromodichloromethane, and others. The full list with the level and data source for each is above.

How many people does Castledale serve?

Castledale reports serving 1,700 people in Utah, per its EPA record.

Has Castledale had any water quality violations?

The EPA has 139 violations on file for Castledale, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.