Is Millsap Wsc Tap Water Safe? Quality Report

Water source: SWP
Ownership: Local government
Counties served: Parker

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

health-based violations

violations on file

still open

Violation	Type	Status	Period
MCL	Health-based	Resolved	2017-04-01 → 2017-06-30
MCL	Health-based	Resolved	2017-04-01 → 2017-06-30
MCL	Health-based	Resolved	2017-04-01 → 2017-06-30
MCL	Health-based	Resolved	2017-04-01 → 2017-06-30
MCL	Health-based	Resolved	2011-05-01 → 2011-05-31
MCL	Health-based	Resolved	2011-05-01 → 2011-05-31
MCL	Health-based	Resolved	2011-05-01 → 2011-05-31
MCL	Health-based	Resolved	2011-05-01 → 2011-05-31
MCL	Health-based	Resolved	2004-10-01 → 2004-12-31
MCL	Health-based	Resolved	2004-10-01 → 2004-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the single worst sample on record — over 100% is worth reading, but is not by itself a violation. Formal violations are listed separately.

Contaminant	Level vs EPA limit	Detection rate	Source	Period
Bromodichloromethane	20.8 µg/L No EPA limit set	45/45	SYR4	2012–2019
Dibromochloromethane	32.9 µg/L No EPA limit set	45/45	SYR4	2012–2019
Dichloroacetic Acid	18.3 µg/L No EPA limit set	45/45	SYR4	2012–2019
TTHM	103 µg/L 129% of the EPA limit, in the worst sample — 80 µg/L	45/45	SYR4	2012–2019
Total Haloacetic Acids (HAA5)	38.2 µg/L 64% of the EPA limit 60 µg/L	45/45	SYR4	2012–2019
Bromoform	57.7 µg/L No EPA limit set	44/45	SYR4	2012–2019
Dibromoacetic Acid	28 µg/L No EPA limit set	44/45	SYR4	2012–2019
Chloroform	17.1 µg/L No EPA limit set	39/45	SYR4	2012–2019
Monobromoacetic Acid	9.9 µg/L No EPA limit set	36/45	SYR4	2012–2019
Trichloroacetic Acid	4.5 µg/L No EPA limit set	24/45	SYR4	2012–2019
Monochloroacetic Acid	4.2 µg/L No EPA limit set	17/45	SYR4	2012–2019
Copper	120 µg/L 9.2% of the EPA limit 1300 µg/L	15/20	SYR4	2015–2018
Lead	0.0 mg/L 0% of the EPA limit 0.0150 mg/L	7/7	LCR	2025
Lead	2.4 µg/L 16% of the EPA limit 15 µg/L	4/20	SYR4	2015–2018

Utility contact

Contact: FRENCH, JAMIE L.
Phone: 940-682-4416
Email: milsapwsc@embarqmail.com

Frequently asked questions about Millsap Wsc

Is Millsap Wsc tap water safe to drink?

EPA monitoring detected 14 contaminants in Millsap Wsc's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Millsap Wsc's water?

EPA monitoring detected Bromodichloromethane, Dibromochloromethane, Dichloroacetic Acid, TTHM, Total Haloacetic Acids (HAA5), and others. The full list with the level and data source for each is above.

How many people does Millsap Wsc serve?

Millsap Wsc reports serving 1,503 people in Texas, per its EPA record.

Has Millsap Wsc had any water quality violations?

The EPA has 29 violations on file for Millsap Wsc, of which 12 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.