Tap WaterIndex

← Texas

Tap water quality report

Quailwood Water

EPA monitoring tested this supplier for 14 contaminants and detected 10. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

14
contaminants tested
10
detected
48
people served
55
health-based violations
Texas rankingsLead in TexasPFAS in Texas
Water source
GWP
Ownership
Private
Counties served
Harris

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

55
health-based violations
96
violations on file
3
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2010-10-01 → 2010-12-31
MCL Health-based Resolved 2010-07-01 → 2010-09-30
MCL Health-based Resolved 2010-04-01 → 2010-06-30
MCL Health-based Resolved 2010-04-01 → 2010-06-30
MCL Health-based Resolved 2010-04-01 → 2010-06-30
MCL Health-based Resolved 2010-04-01 → 2010-06-30
MCL Health-based Resolved 2010-04-01 → 2010-06-30
MCL Health-based Resolved 2010-01-01 → 2010-03-31
MCL Health-based Resolved 2010-01-01 → 2010-03-31
MCL Health-based Resolved 2010-01-01 → 2010-03-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
87.85 µg/L 6.8%
of the EPA limit 1300 µg/L
worst single sample: 110 µg/L
6/15 SYR4 2012–2019
Dibromochloromethane
3.375 µg/L
No EPA limit set
worst single sample: 3.5 µg/L
2/2 SYR4 2016–2019
Lead
0.00026 mg/L 1.7%
of the EPA limit 0.0150 mg/L
 2/2 LCR 2025
TTHM
10.69 µg/L 13%
of the EPA limit 80 µg/L
worst single sample: 11.2 µg/L
2/2 SYR4 2016–2019
Bromodichloromethane
3.3 µg/L
No EPA limit set
 1/2 SYR4 2016–2019
Bromoform
1.4 µg/L
No EPA limit set
 1/2 SYR4 2016–2019
Chloroform
3 µg/L
No EPA limit set
 1/2 SYR4 2016–2019
Dichloroacetic Acid
1.3 µg/L
No EPA limit set
 1/2 SYR4 2016–2019
Lead
0.9200 µg/L 6.1%
of the EPA limit 15 µg/L
 1/15 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
1.3 µg/L 2.2%
of the EPA limit 60 µg/L
 1/2 SYR4 2016–2019
4 contaminants tested, none detected
Dibromoacetic AcidMonobromoacetic AcidMonochloroacetic AcidTrichloroacetic Acid

Utility contact

Contact
GILLEY, DAVID, L
Phone
281-898-1273

Frequently asked questions about Quailwood Water

Is Quailwood Water tap water safe to drink?

EPA monitoring detected 10 contaminants in Quailwood Water's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Quailwood Water's water?

EPA monitoring detected Copper, Dibromochloromethane, Lead, TTHM, Bromodichloromethane, and others. The full list with the level and data source for each is above.

How many people does Quailwood Water serve?

Quailwood Water reports serving 48 people in Texas, per its EPA record.

Has Quailwood Water had any water quality violations?

The EPA has 96 violations on file for Quailwood Water, of which 55 are health-based (a contaminant limit or required treatment was breached) and 3 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.