Is Liberty Danville Fwsd 2 Tap Water Safe? Quality Report

Water source: SWP
Ownership: Local government
Counties served: Gregg

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

health-based violations

violations on file

still open

Violation	Type	Status	Period
MCL	Health-based	Resolved	2025-07-01 → 2025-09-30
MCL	Health-based	Resolved	2025-07-01 → 2025-09-30
MCL	Health-based	Resolved	2025-07-01 → 2025-09-30
MCL	Health-based	Resolved	2025-07-01 → 2025-09-30
MCL	Health-based	Resolved	2025-04-01 → 2025-06-30
MCL	Health-based	Resolved	2025-04-01 → 2025-06-30
MCL	Health-based	Resolved	2025-04-01 → 2025-06-30
MCL	Health-based	Resolved	2025-04-01 → 2025-06-30
MCL	Health-based	Resolved	2025-04-01 → 2025-06-30
MCL	Health-based	Resolved	2025-01-01 → 2025-03-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.

Contaminant	Level vs EPA limit	Detection rate	Source	Period
Bromodichloromethane	38.61 µg/L No EPA limit set worst single sample: 47.8 µg/L	39/39	SYR4	2012–2019
Dibromochloromethane	17.15 µg/L No EPA limit set worst single sample: 28.4 µg/L	39/39	SYR4	2012–2019
TTHM	101.9 µg/L 127% of the EPA limit, at the 95th percentile of samples — 80 µg/L worst single sample: 123 µg/L	39/39	SYR4	2012–2019
Chloroform	44.075 µg/L No EPA limit set worst single sample: 55.9 µg/L	38/39	SYR4	2012–2019
Total Haloacetic Acids (HAA5)	53.855 µg/L 90% of the EPA limit 60 µg/L worst single sample: 67.6 µg/L	34/39	SYR4	2012–2019
Dichloroacetic Acid	29.455 µg/L No EPA limit set worst single sample: 33.7 µg/L	28/39	SYR4	2012–2019
Trichloroacetic Acid	21.735 µg/L No EPA limit set worst single sample: 23.2 µg/L	28/39	SYR4	2012–2019
Bromoform	3.479 µg/L No EPA limit set worst single sample: 4.66 µg/L	23/39	SYR4	2012–2019
Dibromoacetic Acid	5.395 µg/L No EPA limit set worst single sample: 6.2 µg/L	22/39	SYR4	2012–2019
Monochloroacetic Acid	6.14 µg/L No EPA limit set worst single sample: 6.3 µg/L	17/39	SYR4	2012–2019
Copper	153.25 µg/L 12% of the EPA limit 1300 µg/L worst single sample: 169 µg/L	16/20	SYR4	2016–2019
Monobromoacetic Acid	1.525 µg/L No EPA limit set worst single sample: 1.6 µg/L	16/39	SYR4	2012–2019
Lead	0.0 mg/L 0% of the EPA limit 0.0150 mg/L	7/7	LCR	2025
Lead	11.2343 µg/L 75% of the EPA limit 15 µg/L worst single sample: 13.1 µg/L	4/20	SYR4	2016–2019

Utility contact

Contact: TANNER, JIMMY, D
Phone: 903-522-0578

Frequently asked questions about Liberty Danville Fwsd 2

Is Liberty Danville Fwsd 2 tap water safe to drink?

EPA monitoring detected 14 contaminants in Liberty Danville Fwsd 2's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Liberty Danville Fwsd 2's water?

EPA monitoring detected Bromodichloromethane, Dibromochloromethane, TTHM, Chloroform, Total Haloacetic Acids (HAA5), and others. The full list with the level and data source for each is above.

How many people does Liberty Danville Fwsd 2 serve?

Liberty Danville Fwsd 2 reports serving 1,131 people in Texas, per its EPA record.

Has Liberty Danville Fwsd 2 had any water quality violations?

The EPA has 58 violations on file for Liberty Danville Fwsd 2, of which 19 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.