← Texas

Tap water quality report

Shady Creek Section 3 Water

EPA monitoring tested this supplier for 79 contaminants and detected 20. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

79
contaminants tested
20
detected
105
people served
4
health-based violations
Water source
Ground water
Ownership
Private
Counties served
Brazoria

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

4
health-based violations
113
violations on file
4
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 2024-10-17
TT Health-based Resolved 2024-10-17
TT Health-based Resolved 2024-10-17
TT Health-based Resolved 2024-10-17
MR Monitoring Resolved 2025-07-01 → 2025-09-30
MR Monitoring Resolved 2025-07-01 → 2025-09-30
MR Monitoring Resolved 2025-07-01 → 2025-09-30
Other Monitoring Unaddressed 2025-07-01
MON Monitoring Resolved 2025-06-01 → 2025-06-30
MON Monitoring Resolved 2025-06-01 → 2025-06-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
153.1 µg/L 12%
of the EPA limit 1300 µg/L
worst single sample: 240 µg/L
12/13 SYR4 2013–2017
Nitrate
40 µg/L 0.4%
of the EPA limit 10000 µg/L
12/16 SYR4 2012–2019
Chloroform
5.1 µg/L
No EPA limit set
worst single sample: 5.4 µg/L
7/7 SYR4 2015–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
6/6 LCR 2023
Bromodichloromethane
4.2 µg/L
No EPA limit set
worst single sample: 4.6 µg/L
5/7 SYR4 2015–2019
Lead
9.905 µg/L 66%
of the EPA limit 15 µg/L
worst single sample: 11 µg/L
4/13 SYR4 2013–2017
Barium
388.4 µg/L 19%
of the EPA limit 2000 µg/L
worst single sample: 389 µg/L
3/3 SYR4 2013–2019
Combined Radium (-226 And -228)
1.5 pCi/L 30%
of the EPA limit 5 pCi/L
3/3 SYR4 2013–2019
Dibromochloromethane
3.19 µg/L
No EPA limit set
worst single sample: 3.4 µg/L
3/7 SYR4 2015–2019
Fluoride
677 µg/L 17%
of the EPA limit 4000 µg/L
worst single sample: 680 µg/L
3/3 SYR4 2013–2019
Nitrate-Nitrite
49 µg/L 0.5%
of the EPA limit 10000 µg/L
worst single sample: 50 µg/L
3/3 SYR4 2012–2015
Nitrite
20 µg/L 2%
of the EPA limit 1000 µg/L
3/4 SYR4 2012–2019
Selenium
4.73 µg/L 9.5%
of the EPA limit 50 µg/L
worst single sample: 4.8 µg/L
3/3 SYR4 2013–2019
Cyanide
10 µg/L 5%
of the EPA limit 200 µg/L
2/2 SYR4 2014–2018
Dibromoacetic Acid
6.285 µg/L
No EPA limit set
worst single sample: 6.5 µg/L
2/2 SYR4 2016–2019
Dichloroacetic Acid
5.24 µg/L
No EPA limit set
worst single sample: 5.3 µg/L
2/2 SYR4 2016–2019
TTHM
7.73 µg/L 9.7%
of the EPA limit 80 µg/L
worst single sample: 8 µg/L
2/2 SYR4 2016–2019
Total Haloacetic Acids (HAA5)
11.525 µg/L 19%
of the EPA limit 60 µg/L
worst single sample: 11.8 µg/L
2/2 SYR4 2016–2019
Bromoform
3.9 µg/L
No EPA limit set
1/7 SYR4 2015–2019
Gross Beta Particle Activity
5.4 pCi/L
No EPA limit set
1/3 SYR4 2013–2019
59 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAsbestosAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumCombined UraniumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebEthylene DibromideEndrinEthylbenzeneGross Alpha, Excl. Radon And UHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidOxamylPentachlorophenolPicloramSimazineStyreneTetrachloroethyleneThallium, TotalTolueneToxapheneTrichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
MCDONALD, ROBERT
Phone
979-709-4146
Email
bobmcdonald_10@msn.com

Frequently asked questions about Shady Creek Section 3 Water

Is Shady Creek Section 3 Water tap water safe to drink?

EPA monitoring detected 20 contaminants in Shady Creek Section 3 Water's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Shady Creek Section 3 Water's water?

EPA monitoring detected Copper, Nitrate, Chloroform, Lead, Bromodichloromethane, and others. The full list with the level and data source for each is above.

How many people does Shady Creek Section 3 Water serve?

Shady Creek Section 3 Water reports serving 105 people in Texas, per its EPA record.

Has Shady Creek Section 3 Water had any water quality violations?

The EPA has 113 violations on file for Shady Creek Section 3 Water, of which 4 are health-based (a contaminant limit or required treatment was breached) and 4 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.