Tap WaterIndex

← Texas

Tap water quality report

Glenshores Water

EPA monitoring tested this supplier for 79 contaminants and detected 16. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

79
contaminants tested
16
detected
81
people served
0
health-based violations
Texas rankingsLead in TexasPFAS in Texas
Water source
Ground water
Ownership
Private
Counties served
Bosque

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
64
violations on file
0
still open
ViolationTypeStatusPeriod
MR Monitoring Resolved 2025-09-29
MR Monitoring Resolved 2025-09-29
Other Monitoring Resolved 2021-04-18
Other Monitoring Resolved 2021-04-18
Other Monitoring Resolved 2021-03-15
Other Monitoring Resolved 2020-05-31
Other Monitoring Resolved 2020-05-31
MR Monitoring Resolved 2019-10-01
MR Monitoring Resolved 2019-10-01
MR Monitoring Resolved 2019-10-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
15.9 µg/L 1.2%
of the EPA limit 1300 µg/L
worst single sample: 21 µg/L
13/17 SYR4 2012–2019
Nitrate
130 µg/L 1.3%
of the EPA limit 10000 µg/L
 10/14 SYR4 2012–2019
Lead
0.00081 mg/L 5.4%
of the EPA limit 0.0150 mg/L
 7/7 LCR 2025
Barium
54.45 µg/L 2.7%
of the EPA limit 2000 µg/L
worst single sample: 54.5 µg/L
3/3 SYR4 2012–2019
Fluoride
417 µg/L 10%
of the EPA limit 4000 µg/L
worst single sample: 420 µg/L
3/3 SYR4 2013–2019
Nitrate-Nitrite
29.5 µg/L 0.3%
of the EPA limit 10000 µg/L
worst single sample: 30 µg/L
3/3 SYR4 2012–2015
Bromoform
1.77 µg/L
No EPA limit set
worst single sample: 1.8 µg/L
2/11 SYR4 2012–2019
TTHM
1.767 µg/L 2.2%
of the EPA limit 80 µg/L
worst single sample: 1.8 µg/L
2/4 SYR4 2013–2019
Cyanide
30.3 µg/L 15%
of the EPA limit 200 µg/L
 1/3 SYR4 2013–2019
Chloroform
1.14 µg/L
No EPA limit set
 1/11 SYR4 2012–2019
Chromium
2.15 µg/L 2.2%
of the EPA limit 100 µg/L
 1/3 SYR4 2012–2019
Combined Radium (-226 And -228)
1.5 pCi/L 30%
of the EPA limit 5 pCi/L
 1/1 SYR4 2018
Dibromochloromethane
0.6000 µg/L
No EPA limit set
 1/11 SYR4 2012–2019
Lead
1.01 µg/L 6.7%
of the EPA limit 15 µg/L
 1/17 SYR4 2012–2019
Monochloroacetic Acid
2.4 µg/L
No EPA limit set
 1/3 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
2.4 µg/L 4%
of the EPA limit 60 µg/L
 1/3 SYR4 2013–2019
63 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAsbestosAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalBromodichloromethaneChlorobenzeneCadmiumCarbofuranCarbon TetrachlorideChlordaneCombined UraniumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDichloroacetic AcidDinosebEthylene DibromideEndrinEthylbenzeneGross Alpha, Excl. Radon And UGross Beta Particle ActivityHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneToxapheneTrichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
PAYNE, ROBERT
Phone
254-675-3551
Email
crystalclearclifton@gmail.com

Frequently asked questions about Glenshores Water

Is Glenshores Water tap water safe to drink?

EPA monitoring detected 16 contaminants in Glenshores Water's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Glenshores Water's water?

EPA monitoring detected Copper, Nitrate, Lead, Barium, Fluoride, and others. The full list with the level and data source for each is above.

How many people does Glenshores Water serve?

Glenshores Water reports serving 81 people in Texas, per its EPA record.

Has Glenshores Water had any water quality violations?

The EPA has 64 violations on file for Glenshores Water, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.