Tap WaterIndex

← Texas

Tap water quality report

Austin County Wsc 3

EPA monitoring tested this supplier for 14 contaminants and detected 11. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

14
contaminants tested
11
detected
425
people served
3
health-based violations
Texas rankingsLead in TexasPFAS in Texas
Water source
Ground water
Ownership
Local government
Counties served
Austin

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

3
health-based violations
332
violations on file
4
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 2024-10-17
TT Health-based Resolved 2024-10-17
TT Health-based Resolved 2024-10-17
Other Monitoring Unaddressed 2026-04-16
Other Monitoring Unaddressed 2025-07-01
MR Monitoring Resolved 2025-07-01 → 2025-09-30
MR Monitoring Resolved 2025-07-01 → 2025-09-30
MR Monitoring Resolved 2025-07-01 → 2025-09-30
MR Monitoring Resolved 2025-07-01 → 2025-09-30
Other Monitoring Unaddressed 2025-05-15

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the single worst sample on record — over 100% is worth reading, but is not by itself a violation. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
4030 µg/L 310%
of the EPA limit, in the worst sample — 1300 µg/L
 35/42 SYR4 2012–2019
Bromodichloromethane
3.8 µg/L
No EPA limit set
 12/12 SYR4 2013–2019
Bromoform
11.4 µg/L
No EPA limit set
 12/12 SYR4 2013–2019
Dibromochloromethane
8.8 µg/L
No EPA limit set
 12/12 SYR4 2013–2019
Lead
167.9 µg/L 1119%
of the EPA limit, in the worst sample — 15 µg/L
 12/42 SYR4 2012–2019
Dichloroacetic Acid
2.1 µg/L
No EPA limit set
 7/7 SYR4 2013–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 7/7 LCR 2024
TTHM
23.7 µg/L 30%
of the EPA limit 80 µg/L
 7/7 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
5 µg/L 8.3%
of the EPA limit 60 µg/L
 7/7 SYR4 2013–2019
Chloroform
1.9 µg/L
No EPA limit set
 6/12 SYR4 2013–2019
Dibromoacetic Acid
2.9 µg/L
No EPA limit set
 6/7 SYR4 2013–2019
3 contaminants tested, none detected
Monobromoacetic AcidMonochloroacetic AcidTrichloroacetic Acid

Utility contact

Contact
CUCCERRE, PHILLIP, M
Phone
979-865-3022
Email
acwgmanager@gmail.com

Frequently asked questions about Austin County Wsc 3

Is Austin County Wsc 3 tap water safe to drink?

EPA monitoring detected 11 contaminants in Austin County Wsc 3's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Austin County Wsc 3's water?

EPA monitoring detected Copper, Bromodichloromethane, Bromoform, Dibromochloromethane, Lead, and others. The full list with the level and data source for each is above.

How many people does Austin County Wsc 3 serve?

Austin County Wsc 3 reports serving 425 people in Texas, per its EPA record.

Has Austin County Wsc 3 had any water quality violations?

The EPA has 332 violations on file for Austin County Wsc 3, of which 3 are health-based (a contaminant limit or required treatment was breached) and 4 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.