Tap WaterIndex

← Tennessee

Tap water quality report

Arthur-Shawanee Utility District

EPA monitoring tested this supplier for 59 contaminants and detected 4. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

59
contaminants tested
4
detected
10,037
people served
5
health-based violations
Tennessee rankingsLead in TennesseePFAS in Tennessee
Water source
Surface water
Ownership
Local government
Counties served
Claiborne

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

5
health-based violations
30
violations on file
0
still open
ViolationTypeStatusPeriod
TT Health-based Archived 1996-05-01 → 1996-05-31
TT Health-based Archived 1996-05-01 → 1996-05-31
TT Health-based Archived 1996-05-01 → 1996-05-31
TT Health-based Archived 1995-01-01 → 1995-01-31
TT Health-based Archived 1995-01-01 → 1995-01-31
Other Monitoring Resolved 2014-11-01
Other Monitoring Resolved 2014-11-01
Other Monitoring Resolved 2014-11-01
Other Monitoring Resolved 2014-11-01
MR Monitoring Resolved 2011-07-01 → 2011-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
TTHM
84.925 µg/L 106%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 95 µg/L
42/42 SYR4 2014–2019
Total Haloacetic Acids (HAA5)
64.675 µg/L 108%
of the EPA limit, at the 95th percentile of samples — 60 µg/L
worst single sample: 67.6 µg/L
42/42 SYR4 2014–2019
Lead
0.0035 mg/L 24%
of the EPA limit 0.0150 mg/L
 10/10 LCR 2025
Nitrate
877 µg/L 8.8%
of the EPA limit 10000 µg/L
 10/12 SYR4 2014–2019
55 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane11Cl-PF3OUdS2,4-D4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaAtrazineBenzeneChlorobenzeneCarbon TetrachlorideDichloromethaneEthylbenzeneGross Alpha, Excl. Radon And UHfpo-DaNetfosaaNfdhaNmefosaaPfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfunaPicloramStyreneTetrachloroethyleneTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneLithiumO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
GARLAND, ERIC
Phone
423-869-4761
Email
ADMIN@ASUDTN.COM

Frequently asked questions about Arthur-Shawanee Utility District

Is Arthur-Shawanee Utility District tap water safe to drink?

EPA monitoring detected 4 contaminants in Arthur-Shawanee Utility District's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Arthur-Shawanee Utility District's water?

EPA monitoring detected TTHM, Total Haloacetic Acids (HAA5), Lead, Nitrate. The full list with the level and data source for each is above.

How many people does Arthur-Shawanee Utility District serve?

Arthur-Shawanee Utility District reports serving 10,037 people in Tennessee, per its EPA record.

Has Arthur-Shawanee Utility District had any water quality violations?

The EPA has 30 violations on file for Arthur-Shawanee Utility District, of which 5 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.