Tap WaterIndex

← Pennsylvania

Tap water quality report

State Line Muni Svcs Auth

EPA monitoring tested this supplier for 14 contaminants and detected 12. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

14
contaminants tested
12
detected
95
people served
62
health-based violations
Pennsylvania rankingsLead in PennsylvaniaPFAS in Pennsylvania
Water source
SWP
Ownership
Local government
Counties served
Fayette

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

62
health-based violations
1,050
violations on file
16
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 2021-09-12
TT Health-based Resolved 2021-09-12
TT Health-based Resolved 2021-09-12
TT Health-based Resolved 2021-09-01
TT Health-based Resolved 2021-09-01
TT Health-based Resolved 2021-09-01
TT Health-based Resolved 2021-08-01
TT Health-based Resolved 2021-08-01
TT Health-based Resolved 2021-08-01
TT Health-based Resolved 2021-07-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the single worst sample on record — over 100% is worth reading, but is not by itself a violation. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Bromodichloromethane
41 µg/L
No EPA limit set
 39/39 SYR4 2013–2019
TTHM
147 µg/L 184%
of the EPA limit, in the worst sample — 80 µg/L
 39/39 SYR4 2013–2019
Chloroform
77.7 µg/L
No EPA limit set
 38/38 SYR4 2013–2019
Dibromochloromethane
26 µg/L
No EPA limit set
 38/39 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
65 µg/L 108%
of the EPA limit, in the worst sample — 60 µg/L
 37/37 SYR4 2013–2019
Copper
58.3 µg/L 4.5%
of the EPA limit 1300 µg/L
 13/13 SYR4 2013–2019
Dichloroacetic Acid
14.2 µg/L
No EPA limit set
 13/13 SYR4 2014–2019
Trichloroacetic Acid
25.7 µg/L
No EPA limit set
 13/13 SYR4 2014–2019
Lead
3 µg/L 20%
of the EPA limit 15 µg/L
 5/10 SYR4 2013–2019
Lead
0.0020 mg/L 13%
of the EPA limit 0.0150 mg/L
 2/2 LCR 1996
Monochloroacetic Acid
56 µg/L
No EPA limit set
 2/13 SYR4 2014–2019
Bromoform
4.12 µg/L
No EPA limit set
 1/39 SYR4 2013–2019
2 contaminants tested, none detected
Dibromoacetic AcidMonobromoacetic Acid

Utility contact

Contact
CLARK SPITZNOGL
Phone
724-557-1210

Frequently asked questions about State Line Muni Svcs Auth

Is State Line Muni Svcs Auth tap water safe to drink?

EPA monitoring detected 12 contaminants in State Line Muni Svcs Auth's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in State Line Muni Svcs Auth's water?

EPA monitoring detected Bromodichloromethane, TTHM, Chloroform, Dibromochloromethane, Total Haloacetic Acids (HAA5), and others. The full list with the level and data source for each is above.

How many people does State Line Muni Svcs Auth serve?

State Line Muni Svcs Auth reports serving 95 people in Pennsylvania, per its EPA record.

Has State Line Muni Svcs Auth had any water quality violations?

The EPA has 1050 violations on file for State Line Muni Svcs Auth, of which 62 are health-based (a contaminant limit or required treatment was breached) and 16 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.