← Ohio

Tap water quality report

Antwerp Village

EPA monitoring tested this supplier for 54 contaminants and detected 18. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

54
contaminants tested
18
detected
1,741
people served
23
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Paulding

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

23
health-based violations
61
violations on file
4
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 1994-10-01 → 1994-10-31
MCL Health-based Resolved 1994-10-01 → 1994-10-31
MCL Health-based Resolved 1994-10-01 → 1994-10-31
MCL Health-based Resolved 1994-10-01 → 1994-10-31
MCL Health-based Resolved 1994-08-01 → 1994-08-31
MCL Health-based Resolved 1994-08-01 → 1994-08-31
MCL Health-based Resolved 1994-08-01 → 1994-08-31
MCL Health-based Resolved 1994-08-01 → 1994-08-31
MCL Health-based Resolved 1994-08-01 → 1994-08-31
MCL Health-based Resolved 1994-08-01 → 1994-08-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
506.4 µg/L 39%
of the EPA limit 1300 µg/L
worst single sample: 585 µg/L
25/40 SYR4 2012–2019
Lead
0.0058 mg/L 39%
of the EPA limit 0.0150 mg/L
21/21 LCR 2025
Bromodichloromethane
8.296 µg/L
No EPA limit set
worst single sample: 9.19 µg/L
13/13 SYR4 2013–2019
Bromoform
16.26 µg/L
No EPA limit set
worst single sample: 21.6 µg/L
13/13 SYR4 2013–2019
Chloroform
3.58 µg/L
No EPA limit set
worst single sample: 3.7 µg/L
13/13 SYR4 2013–2019
Dibromochloromethane
17.12 µg/L
No EPA limit set
worst single sample: 17.3 µg/L
13/13 SYR4 2013–2019
TTHM
44.54 µg/L 56%
of the EPA limit 80 µg/L
worst single sample: 48.2 µg/L
13/13 SYR4 2013–2019
Dibromoacetic Acid
5.85 µg/L
No EPA limit set
worst single sample: 6.5 µg/L
11/13 SYR4 2013–2019
Dichloroacetic Acid
2.3185 µg/L
No EPA limit set
worst single sample: 2.49 µg/L
8/13 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
10.795 µg/L 18%
of the EPA limit 60 µg/L
worst single sample: 10.9 µg/L
8/13 SYR4 2013–2019
Fluoride
2277.5 µg/L 57%
of the EPA limit 4000 µg/L
worst single sample: 2290 µg/L
6/6 SYR4 2013–2019
Trichloroacetic Acid
2.175 µg/L
No EPA limit set
worst single sample: 2.3 µg/L
6/13 SYR4 2013–2019
Barium
36.04 µg/L 1.8%
of the EPA limit 2000 µg/L
worst single sample: 36.6 µg/L
5/6 SYR4 2013–2019
Monobromoacetic Acid
1.26 µg/L
No EPA limit set
worst single sample: 1.3 µg/L
5/13 SYR4 2013–2019
Lead
31.71 µg/L 211%
of the EPA limit, at the 95th percentile of samples — 15 µg/L
worst single sample: 34.8 µg/L
4/40 SYR4 2012–2019
Monochloroacetic Acid
4.345 µg/L
No EPA limit set
worst single sample: 4.4 µg/L
2/13 SYR4 2013–2019
Cadmium
5.4 µg/L 108%
of the EPA limit, at the 95th percentile of samples — 5 µg/L
1/7 SYR4 2013–2019
Combined Radium (-226 And -228)
1.9 pCi/L 38%
of the EPA limit 5 pCi/L
1/1 SYR4 2019
36 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalArsenicAsbestosAtrazineBenzeneBeryllium, TotalChlorobenzeneCyanideCarbon TetrachlorideChromiumDichloromethaneEthylbenzeneLassoMercuryNitrateNitrate-NitriteNitriteSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
DAVIS, BRIAN
Phone
419-258-2371
Email
admin@villageofantwerp.com

Frequently asked questions about Antwerp Village

Is Antwerp Village tap water safe to drink?

EPA monitoring detected 18 contaminants in Antwerp Village's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Antwerp Village's water?

EPA monitoring detected Copper, Lead, Bromodichloromethane, Bromoform, Chloroform, and others. The full list with the level and data source for each is above.

How many people does Antwerp Village serve?

Antwerp Village reports serving 1,741 people in Ohio, per its EPA record.

Has Antwerp Village had any water quality violations?

The EPA has 61 violations on file for Antwerp Village, of which 23 are health-based (a contaminant limit or required treatment was breached) and 4 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.