Tap WaterIndex

← Ohio

Tap water quality report

Farmersville Village

EPA monitoring tested this supplier for 53 contaminants and detected 15. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

53
contaminants tested
15
detected
975
people served
12
health-based violations
Ohio rankingsLead in OhioPFAS in Ohio
Water source
Ground water
Ownership
Local government
Counties served
Montgomery

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

12
health-based violations
79
violations on file
1
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 1994-08-01 → 1994-08-31
MCL Health-based Resolved 1994-08-01 → 1994-08-31
MCL Health-based Resolved 1994-08-01 → 1994-08-31
MCL Health-based Resolved 1994-08-01 → 1994-08-31
MCL Health-based Resolved 1994-08-01 → 1994-08-31
MCL Health-based Resolved 1994-08-01 → 1994-08-31
MCL Health-based Resolved 1994-08-01 → 1994-08-31
MCL Health-based Resolved 1994-08-01 → 1994-08-31
MCL Health-based Resolved 1992-06-01 → 1992-06-30
MCL Health-based Resolved 1992-06-01 → 1992-06-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
224.15 µg/L 17%
of the EPA limit 1300 µg/L
worst single sample: 246 µg/L
20/20 SYR4 2014–2017
Bromodichloromethane
11.117 µg/L
No EPA limit set
worst single sample: 12.29 µg/L
18/18 SYR4 2012–2019
Chloroform
15.47 µg/L
No EPA limit set
worst single sample: 39.07 µg/L
17/18 SYR4 2012–2019
Dibromochloromethane
11.106 µg/L
No EPA limit set
worst single sample: 13.85 µg/L
17/18 SYR4 2012–2019
Lead
0.0021 mg/L 14%
of the EPA limit 0.0150 mg/L
 17/17 LCR 2025
Bromoform
5.219 µg/L
No EPA limit set
worst single sample: 5.38 µg/L
15/18 SYR4 2012–2019
Dibromoacetic Acid
3.4073 µg/L
No EPA limit set
worst single sample: 4.206 µg/L
15/15 SYR4 2012–2019
TTHM
47.192 µg/L 59%
of the EPA limit 80 µg/L
worst single sample: 64.65 µg/L
15/15 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
9.0251 µg/L 15%
of the EPA limit 60 µg/L
worst single sample: 11.9 µg/L
15/15 SYR4 2012–2019
Dichloroacetic Acid
5.76675 µg/L
No EPA limit set
worst single sample: 6.343 µg/L
6/15 SYR4 2012–2019
Lead
8.714 µg/L 58%
of the EPA limit 15 µg/L
worst single sample: 9.74 µg/L
4/20 SYR4 2014–2017
Arsenic
5.243 µg/L 52%
of the EPA limit 10 µg/L
worst single sample: 5.32 µg/L
3/3 SYR4 2012–2018
Barium
492.8 µg/L 25%
of the EPA limit 2000 µg/L
worst single sample: 496 µg/L
3/3 SYR4 2012–2018
Fluoride
1027 µg/L 26%
of the EPA limit 4000 µg/L
worst single sample: 1040 µg/L
3/3 SYR4 2012–2018
Trichloroacetic Acid
2.8577 µg/L
No EPA limit set
worst single sample: 2.998 µg/L
3/15 SYR4 2012–2019
38 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalAtrazineBenzeneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbon TetrachlorideChromiumDichloromethaneEthylbenzeneGross Beta Particle ActivityLassoMercuryMonobromoacetic AcidMonochloroacetic AcidNitrateNitrate-NitriteNitriteSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
SHELL, DEREK
Phone
937-833-2135
Email
dshell@farmersville.us

Frequently asked questions about Farmersville Village

Is Farmersville Village tap water safe to drink?

EPA monitoring detected 15 contaminants in Farmersville Village's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Farmersville Village's water?

EPA monitoring detected Copper, Bromodichloromethane, Chloroform, Dibromochloromethane, Lead, and others. The full list with the level and data source for each is above.

How many people does Farmersville Village serve?

Farmersville Village reports serving 975 people in Ohio, per its EPA record.

Has Farmersville Village had any water quality violations?

The EPA has 79 violations on file for Farmersville Village, of which 12 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.