Tap WaterIndex

← Ohio

Tap water quality report

Napoleon City

EPA monitoring tested this supplier for 97 contaminants and detected 25. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

97
contaminants tested
25
detected
8,858
people served
94
health-based violations
Ohio rankingsLead in OhioPFAS in Ohio
Water source
Surface water
Ownership
Local government
Counties served
Henry

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

94
health-based violations
103
violations on file
0
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 2015-03-01 → 2015-03-31
TT Health-based Resolved 2015-03-01 → 2015-03-31
TT Health-based Resolved 2015-03-01 → 2015-03-31
TT Health-based Resolved 2015-03-01 → 2015-03-31
MCL Health-based Resolved 2008-10-01 → 2008-12-31
MCL Health-based Resolved 2008-10-01 → 2008-12-31
MCL Health-based Resolved 2008-10-01 → 2008-12-31
MCL Health-based Resolved 2008-10-01 → 2008-12-31
MCL Health-based Resolved 2008-10-01 → 2008-12-31
MCL Health-based Resolved 2008-07-01 → 2008-09-30

PFAS detected

PFAS are industrial “forever chemicals”. These are the EPA's latest nationwide test results (2023–2025).
ContaminantMaxDetection ratePeriod
Pfpea 0.0091 µg/L 2/4 2024
PFBS 0.0036 µg/L 1/4 2024
Pfhxa 0.0071 µg/L 1/4 2024

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
7440 µg/L 74%
of the EPA limit 10000 µg/L
worst single sample: 9650 µg/L
746/748 SYR4 2012–2019
Bromodichloromethane
20.84 µg/L
No EPA limit set
worst single sample: 29.2 µg/L
64/64 SYR4 2012–2019
Chloroform
39.425 µg/L
No EPA limit set
worst single sample: 51.1 µg/L
64/64 SYR4 2012–2019
Dibromochloromethane
16.67 µg/L
No EPA limit set
worst single sample: 20.3 µg/L
64/64 SYR4 2012–2019
Dichloroacetic Acid
13.38 µg/L
No EPA limit set
worst single sample: 16.4 µg/L
62/62 SYR4 2012–2019
TTHM
70.27 µg/L 88%
of the EPA limit 80 µg/L
worst single sample: 90.8 µg/L
62/62 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
26.5 µg/L 44%
of the EPA limit 60 µg/L
worst single sample: 37.7 µg/L
62/62 SYR4 2012–2019
Trichloroacetic Acid
7.595 µg/L
No EPA limit set
worst single sample: 10.2 µg/L
62/62 SYR4 2012–2019
Bromoform
4.345 µg/L
No EPA limit set
worst single sample: 8.8 µg/L
52/64 SYR4 2012–2019
Dibromoacetic Acid
5.965 µg/L
No EPA limit set
worst single sample: 7 µg/L
52/62 SYR4 2012–2019
Atrazine
5.293 µg/L 176%
of the EPA limit, at the 95th percentile of samples — 3 µg/L
worst single sample: 11 µg/L
47/68 SYR4 2012–2019
Copper
47.8 µg/L 3.7%
of the EPA limit 1300 µg/L
worst single sample: 79 µg/L
47/168 SYR4 2014–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 26/26 LCR 2025
Simazine
0.5618 µg/L 14%
of the EPA limit 4 µg/L
worst single sample: 1.41 µg/L
25/69 SYR4 2012–2019
Monochloroacetic Acid
14.3 µg/L
No EPA limit set
worst single sample: 22.7 µg/L
13/62 SYR4 2012–2019
Lead
17 µg/L 113%
of the EPA limit, at the 95th percentile of samples — 15 µg/L
worst single sample: 21 µg/L
11/168 SYR4 2014–2019
Fluoride
1091.2 µg/L 27%
of the EPA limit 4000 µg/L
worst single sample: 1150 µg/L
8/8 SYR4 2012–2019
Barium
14.4 µg/L 0.7%
of the EPA limit 2000 µg/L
worst single sample: 15 µg/L
4/8 SYR4 2012–2019
Monobromoacetic Acid
2.09 µg/L
No EPA limit set
worst single sample: 2.1 µg/L
3/62 SYR4 2012–2019
Xylenes, Total
2.75 µg/L 0%
of the EPA limit 10000 µg/L
worst single sample: 2.8 µg/L
3/12 SYR4 2012–2019
2,4-D
0.2000 µg/L 0.3%
of the EPA limit 70 µg/L
 1/3 SYR4 2013–2019
Ethylbenzene
0.5000 µg/L 0.1%
of the EPA limit 700 µg/L
 1/12 SYR4 2012–2019
72 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane11Cl-PF3OUdS4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaAntimony, TotalArsenicAsbestosBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChromiumDichloromethaneDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDiquatEndothallGlyphosateHfpo-DaLassoMercuryMethoxychlorNetfosaaNfdhaNmefosaaNitrate-NitriteNitriteOxamylPfbaPfdaPfdoaPfeesaPfhpaPfhpsPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpesPftaPftrdaPfunaPentachlorophenolPicloramSeleniumStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)TrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneLithiumO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
SMALL, JAMES A
Phone
419-592-4010
Email
jsmall@napoleonohio.com

Frequently asked questions about Napoleon City

Is Napoleon City tap water safe to drink?

EPA monitoring detected 25 contaminants in Napoleon City's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Napoleon City's water?

EPA monitoring detected Nitrate, Bromodichloromethane, Chloroform, Dibromochloromethane, Dichloroacetic Acid, and others. The full list with the level and data source for each is above.

How many people does Napoleon City serve?

Napoleon City reports serving 8,858 people in Ohio, per its EPA record.

Has Napoleon City had any water quality violations?

The EPA has 103 violations on file for Napoleon City, of which 94 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.