← New York

Tap water quality report

Alpine Acres Water District

EPA monitoring tested this supplier for 48 contaminants and detected 9. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

48
contaminants tested
9
detected
222
people served
0
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Putnam

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
6
violations on file
0
still open
ViolationTypeStatusPeriod
Other Monitoring Resolved 2004-11-04
Other Monitoring Resolved 2004-11-04
Other Monitoring Resolved 2004-11-04
MR Monitoring Archived 1999-02-01 → 1999-02-28
MR Monitoring Archived 1995-01-01 → 1995-12-31
MR Monitoring Archived 1994-01-01 → 1994-06-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
500 µg/L 5%
of the EPA limit 10000 µg/L
8/8 SYR4 2012–2018
Lead
0.0060 mg/L 40%
of the EPA limit 0.0150 mg/L
7/7 LCR 2026
Bromodichloromethane
0.7855 µg/L
No EPA limit set
worst single sample: 0.8000 µg/L
2/5 SYR4 2012–2018
Chloroform
0.8420 µg/L
No EPA limit set
worst single sample: 0.8500 µg/L
2/5 SYR4 2012–2018
TTHM
2.264 µg/L 2.8%
of the EPA limit 80 µg/L
worst single sample: 2.32 µg/L
2/5 SYR4 2012–2018
Barium
13 µg/L 0.7%
of the EPA limit 2000 µg/L
1/1 SYR4 2013
Combined Uranium
1.6 µg/L 5.3%
of the EPA limit 30 µg/L
1/1 SYR4 2017
Dibromochloromethane
0.6700 µg/L
No EPA limit set
1/5 SYR4 2012–2018
Fluoride
12000 µg/L 300%
of the EPA limit, at the 95th percentile of samples — 4000 µg/L
1/1 SYR4 2013
39 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalArsenicAsbestosBenzeneBeryllium, TotalBromoformChlorobenzeneCyanideCadmiumCarbon TetrachlorideChromiumCombined Radium (-226 And -228)DichloromethaneDibromoacetic AcidDichloroacetic AcidEthylbenzeneGross Alpha, Excl. Radon And UMercuryMonobromoacetic AcidMonochloroacetic AcidSeleniumStyreneTetrachloroethyleneThallium, TotalTolueneTotal Haloacetic Acids (HAA5)Trichloroacetic AcidTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
PATTERSON TOWN SUPERVISOR
Phone
845-878-6500

Frequently asked questions about Alpine Acres Water District

Is Alpine Acres Water District tap water safe to drink?

EPA monitoring detected 9 contaminants in Alpine Acres Water District's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Alpine Acres Water District's water?

EPA monitoring detected Nitrate, Lead, Bromodichloromethane, Chloroform, TTHM, and others. The full list with the level and data source for each is above.

How many people does Alpine Acres Water District serve?

Alpine Acres Water District reports serving 222 people in New York, per its EPA record.

Has Alpine Acres Water District had any water quality violations?

The EPA has 6 violations on file for Alpine Acres Water District, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.