Tap WaterIndex

← New York

Tap water quality report

Ashland Water District

EPA monitoring tested this supplier for 62 contaminants and detected 7. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

62
contaminants tested
7
detected
200
people served
0
health-based violations
New York rankingsLead in New YorkPFAS in New York
Water source
Ground water
Ownership
Local government
Counties served
Greene

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
44
violations on file
6
still open
ViolationTypeStatusPeriod
MR Monitoring Unaddressed 2025-07-01
MR Monitoring Unaddressed 2025-07-01
MR Monitoring Resolved 2022-01-01 → 2022-12-31
MR Monitoring Resolved 2022-01-01 → 2022-12-31
MR Monitoring Resolved 2022-01-01 → 2022-12-31
MR Monitoring Resolved 2022-01-01 → 2022-12-31
MR Monitoring Resolved 2022-01-01 → 2022-12-31
MR Monitoring Resolved 2022-01-01 → 2022-12-31
Other Monitoring Resolved 2021-01-01
Other Monitoring Resolved 2021-01-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the single worst sample on record — over 100% is worth reading, but is not by itself a violation. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 20/20 LCR 2025
Nitrate
540 µg/L 5.4%
of the EPA limit 10000 µg/L
 14/14 SYR4 2013–2019
Barium
8 µg/L 0.4%
of the EPA limit 2000 µg/L
 2/3 SYR4 2013–2018
Dibromochloromethane
0.5000 µg/L
No EPA limit set
 1/1 SYR4 2013
Fluoride
130 µg/L 3.3%
of the EPA limit 4000 µg/L
 1/3 SYR4 2013–2018
TTHM
4.82 µg/L 6%
of the EPA limit 80 µg/L
 1/1 SYR4 2016
Total Haloacetic Acids (HAA5)
2.8 µg/L 4.7%
of the EPA limit 60 µg/L
 1/1 SYR4 2016
55 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumCombined Radium (-226 And -228)DichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebEthylene DibromideEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
ASHLAND SUPERVISOR AND TOWN BOARD
Phone
518-734-3636
Email
ashland12407@gmail.com

Frequently asked questions about Ashland Water District

Is Ashland Water District tap water safe to drink?

EPA monitoring detected 7 contaminants in Ashland Water District's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Ashland Water District's water?

EPA monitoring detected Lead, Nitrate, Barium, Dibromochloromethane, Fluoride, and others. The full list with the level and data source for each is above.

How many people does Ashland Water District serve?

Ashland Water District reports serving 200 people in New York, per its EPA record.

Has Ashland Water District had any water quality violations?

The EPA has 44 violations on file for Ashland Water District, of which 0 are health-based (a contaminant limit or required treatment was breached) and 6 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.