Tap WaterIndex

← North Carolina

Tap water quality report

Ward`S Mhp

EPA monitoring tested this supplier for 76 contaminants and detected 6. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

76
contaminants tested
6
detected
41
people served
0
health-based violations
North Carolina rankingsLead in North CarolinaPFAS in North Carolina
Water source
Ground water
Ownership
Private
Counties served
Guilford

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
89
violations on file
11
still open
ViolationTypeStatusPeriod
Other Monitoring Resolved 2025-12-19
Other Monitoring Resolved 2025-12-19
Other Monitoring Resolved 2025-12-19
Other Monitoring Resolved 2025-12-19
Other Monitoring Resolved 2025-12-19
Other Monitoring Resolved 2025-12-19
Other Monitoring Addressed 2025-11-19
Other Monitoring Addressed 2025-11-19
Other Monitoring Resolved 2025-07-01
Other Monitoring Resolved 2025-07-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the single worst sample on record — over 100% is worth reading, but is not by itself a violation. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Fluoride
148 µg/L 3.7%
of the EPA limit 4000 µg/L
 2/3 SYR4 2012–2019
Copper
162 µg/L 12%
of the EPA limit 1300 µg/L
 1/15 SYR4 2012–2018
Combined Radium (-226 And -228)
0.8800 pCi/L 18%
of the EPA limit 5 pCi/L
 1/2 SYR4 2013–2016
Dibromochloromethane
1.1 µg/L
No EPA limit set
 1/3 SYR4 2014–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 1/1 LCR 2022
TTHM
1.1 µg/L 1.4%
of the EPA limit 80 µg/L
 1/2 SYR4 2014–2017
70 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBhc-GammaBariumBenzeneBenzo(A)PyreneBeryllium, TotalBromodichloromethaneBromoformChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChloroformChromiumCombined UraniumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDichloroacetic AcidDinosebEthylene DibromideEndrinEthylbenzeneGross Alpha, Excl. Radon And UHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoLeadMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNitrateOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Haloacetic Acids (HAA5)Total Polychlorinated Biphenyls (PCB)ToxapheneTrichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
WARD, SANDRA
Phone
336-215-6149
Email
scw674@aol.com

Frequently asked questions about Ward`S Mhp

Is Ward`S Mhp tap water safe to drink?

EPA monitoring detected 6 contaminants in Ward`S Mhp's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Ward`S Mhp's water?

EPA monitoring detected Fluoride, Copper, Combined Radium (-226 And -228), Dibromochloromethane, Lead, and others. The full list with the level and data source for each is above.

How many people does Ward`S Mhp serve?

Ward`S Mhp reports serving 41 people in North Carolina, per its EPA record.

Has Ward`S Mhp had any water quality violations?

The EPA has 89 violations on file for Ward`S Mhp, of which 0 are health-based (a contaminant limit or required treatment was breached) and 11 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.