Tap WaterIndex

← North Carolina

Tap water quality report

Country Acres Mh S/D

EPA monitoring tested this supplier for 14 contaminants and detected 5. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

14
contaminants tested
5
detected
168
people served
25
health-based violations
North Carolina rankingsLead in North CarolinaPFAS in North Carolina
Water source
SWP
Ownership
Private
Counties served
Cabarrus

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

25
health-based violations
488
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2014-10-01 → 2014-12-31
MCL Health-based Resolved 2014-10-01 → 2014-12-31
MCL Health-based Resolved 2014-10-01 → 2014-12-31
MCL Health-based Resolved 2014-10-01 → 2014-12-31
MCL Health-based Resolved 2014-10-01 → 2014-12-31
MCL Health-based Resolved 2014-07-01 → 2014-09-30
MCL Health-based Resolved 2014-07-01 → 2014-09-30
MCL Health-based Resolved 2014-07-01 → 2014-09-30
MCL Health-based Resolved 2014-07-01 → 2014-09-30
MCL Health-based Resolved 2014-07-01 → 2014-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the single worst sample on record — over 100% is worth reading, but is not by itself a violation. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
309 µg/L 24%
of the EPA limit 1300 µg/L
 11/21 SYR4 2012–2018
Lead
6.5 µg/L 43%
of the EPA limit 15 µg/L
 9/21 SYR4 2012–2018
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 2/2 LCR 2025
Monobromoacetic Acid
1.5 µg/L
No EPA limit set
 1/2 SYR4 2016–2019
Total Haloacetic Acids (HAA5)
1 µg/L 1.7%
of the EPA limit 60 µg/L
 1/5 SYR4 2013–2019
9 contaminants tested, none detected
BromodichloromethaneBromoformChloroformDibromoacetic AcidDibromochloromethaneDichloroacetic AcidMonochloroacetic AcidTTHMTrichloroacetic Acid

Utility contact

Contact
MILLIRON, BRENT
Phone
919-653-6999
Email
bmilliron@aquaamerica.com

Frequently asked questions about Country Acres Mh S/D

Is Country Acres Mh S/D tap water safe to drink?

EPA monitoring detected 5 contaminants in Country Acres Mh S/D's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Country Acres Mh S/D's water?

EPA monitoring detected Copper, Lead, Lead, Monobromoacetic Acid, Total Haloacetic Acids (HAA5). The full list with the level and data source for each is above.

How many people does Country Acres Mh S/D serve?

Country Acres Mh S/D reports serving 168 people in North Carolina, per its EPA record.

Has Country Acres Mh S/D had any water quality violations?

The EPA has 488 violations on file for Country Acres Mh S/D, of which 25 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.