← Montana

Tap water quality report

Hilldale Colony

EPA monitoring tested this supplier for 14 contaminants and detected 14. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

14
contaminants tested
14
detected
79
people served
0
health-based violations
Water source
SWP
Ownership
Private
Counties served
Hill

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
152
violations on file
0
still open
ViolationTypeStatusPeriod
MR Monitoring Resolved 2024-10-01 → 2024-10-31
MR Monitoring Resolved 2024-10-01 → 2024-10-31
MR Monitoring Resolved 2024-10-01 → 2024-10-31
MR Monitoring Resolved 2024-01-01 → 2024-01-31
MR Monitoring Resolved 2024-01-01 → 2024-01-31
MR Monitoring Resolved 2024-01-01 → 2024-01-31
MR Monitoring Resolved 2019-10-01 → 2020-09-30
MR Monitoring Resolved 2019-10-01 → 2020-09-30
MR Monitoring Resolved 2019-10-01 → 2020-09-30
MR Monitoring Resolved 2019-10-01 → 2020-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the single worst sample on record — over 100% is worth reading, but is not by itself a violation. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
109 µg/L 8.4%
of the EPA limit 1300 µg/L
12/12 SYR4 2014–2017
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
8/8 LCR 2017
Dibromochloromethane
17 µg/L
No EPA limit set
5/5 SYR4 2013–2019
TTHM
44 µg/L 55%
of the EPA limit 80 µg/L
5/5 SYR4 2013–2019
Bromoform
5.1 µg/L
No EPA limit set
4/5 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
17.6 µg/L 29%
of the EPA limit 60 µg/L
4/4 SYR4 2013–2019
Bromodichloromethane
15 µg/L
No EPA limit set
3/5 SYR4 2013–2019
Chloroform
19.1 µg/L
No EPA limit set
3/5 SYR4 2013–2019
Dibromoacetic Acid
4.7 µg/L
No EPA limit set
3/4 SYR4 2013–2019
Dichloroacetic Acid
11 µg/L
No EPA limit set
3/4 SYR4 2013–2019
Trichloroacetic Acid
6.37 µg/L
No EPA limit set
3/4 SYR4 2013–2019
Monobromoacetic Acid
0.7900 µg/L
No EPA limit set
2/4 SYR4 2013–2019
Monochloroacetic Acid
1.2 µg/L
No EPA limit set
2/4 SYR4 2013–2019
Lead
3 µg/L 20%
of the EPA limit 15 µg/L
1/12 SYR4 2014–2017

Utility contact

Contact
KLEINSASSER, SAM S
Phone
406-398-5342
Email
hdplumbing@itstriangle.com

Frequently asked questions about Hilldale Colony

Is Hilldale Colony tap water safe to drink?

EPA monitoring detected 14 contaminants in Hilldale Colony's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Hilldale Colony's water?

EPA monitoring detected Copper, Lead, Dibromochloromethane, TTHM, Bromoform, and others. The full list with the level and data source for each is above.

How many people does Hilldale Colony serve?

Hilldale Colony reports serving 79 people in Montana, per its EPA record.

Has Hilldale Colony had any water quality violations?

The EPA has 152 violations on file for Hilldale Colony, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.