← Minnesota

Tap water quality report

Indian Hills Development

EPA monitoring tested this supplier for 71 contaminants and detected 9. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

71
contaminants tested
9
detected
156
people served
26
health-based violations
Water source
Ground water
Ownership
Private
Counties served
Washington

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

26
health-based violations
32
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2005-10-01 → 2005-12-31
MCL Health-based Resolved 2005-10-01 → 2005-12-31
MCL Health-based Resolved 2005-10-01 → 2005-12-31
MCL Health-based Resolved 2005-10-01 → 2005-12-31
MCL Health-based Resolved 2005-10-01 → 2005-12-31
MCL Health-based Resolved 2005-10-01 → 2005-12-31
MCL Health-based Resolved 2004-10-01 → 2004-12-31
MCL Health-based Resolved 2004-10-01 → 2004-12-31
MCL Health-based Resolved 2004-10-01 → 2004-12-31
MCL Health-based Resolved 2004-10-01 → 2004-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate-Nitrite
3400 µg/L 34%
of the EPA limit 10000 µg/L
16/16 SYR4 2012–2019
Copper
354.1 µg/L 27%
of the EPA limit 1300 µg/L
worst single sample: 409 µg/L
10/10 SYR4 2014–2017
Lead
2.76 µg/L 18%
of the EPA limit 15 µg/L
worst single sample: 3.3 µg/L
10/10 SYR4 2014–2017
Bromodichloromethane
1.94 µg/L
No EPA limit set
worst single sample: 2.1 µg/L
5/7 SYR4 2012–2019
Chloroform
3.44 µg/L
No EPA limit set
worst single sample: 3.7 µg/L
5/7 SYR4 2012–2019
Dibromochloromethane
1.54 µg/L
No EPA limit set
worst single sample: 1.6 µg/L
5/7 SYR4 2012–2019
Lead
0.0030 mg/L 20%
of the EPA limit 0.0150 mg/L
2/2 LCR 2023
Bromoform
0.6000 µg/L
No EPA limit set
1/7 SYR4 2012–2019
Simazine
0.0700 µg/L 1.8%
of the EPA limit 4 µg/L
1/2 SYR4 2013–2019
62 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBhc-GammaBariumBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDichloroacetic AcidDinosebEthylene DibromideEndrinEthylbenzeneFluorideGlyphosateGross Alpha, Excl. Radon And UHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidOxamylPentachlorophenolPicloramSeleniumStyreneTetrachloroethyleneThallium, TotalTolueneToxapheneTrichloroacetic AcidTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Phone
6517702301
Email
cindy@ihgolf.com

Frequently asked questions about Indian Hills Development

Is Indian Hills Development tap water safe to drink?

EPA monitoring detected 9 contaminants in Indian Hills Development's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Indian Hills Development's water?

EPA monitoring detected Nitrate-Nitrite, Copper, Lead, Bromodichloromethane, Chloroform, and others. The full list with the level and data source for each is above.

How many people does Indian Hills Development serve?

Indian Hills Development reports serving 156 people in Minnesota, per its EPA record.

Has Indian Hills Development had any water quality violations?

The EPA has 32 violations on file for Indian Hills Development, of which 26 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.