Tap WaterIndex

← Massachusetts

Tap water quality report

Village at Highland Park

EPA monitoring tested this supplier for 61 contaminants and detected 4. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

61
contaminants tested
4
detected
50
people served
9
health-based violations
Massachusetts rankingsLead in MassachusettsPFAS in Massachusetts
Water source
Ground water
Ownership
Private
Counties served
Middlesex

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

9
health-based violations
19
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2015-06-01 → 2015-06-30
MCL Health-based Resolved 2015-06-01 → 2015-06-30
MCL Health-based Resolved 2013-09-01 → 2013-09-30
MCL Health-based Resolved 2013-09-01 → 2013-09-30
MCL Health-based Archived 2012-09-01 → 2012-09-30
MCL Health-based Archived 2012-09-01 → 2012-09-30
MCL Health-based Archived 2012-08-01 → 2012-08-31
MCL Health-based Resolved 2003-07-01 → 2003-07-31
MCL Health-based Resolved 2003-07-01 → 2003-07-31
MR Monitoring Resolved 2003-08-01 → 2003-08-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
3656 µg/L 37%
of the EPA limit 10000 µg/L
worst single sample: 4250 µg/L
32/32 SYR4 2012–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 17/17 LCR 2027
Barium
13.4 µg/L 0.7%
of the EPA limit 2000 µg/L
worst single sample: 14 µg/L
4/4 SYR4 2014–2017
Fluoride
641.55 µg/L 16%
of the EPA limit 4000 µg/L
worst single sample: 649 µg/L
2/4 SYR4 2014–2017
57 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCopperCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebEthylene DibromideEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
APRIL BLAIS
Phone
5084357267
Email
APRIL@RRRMGT.COM

Frequently asked questions about Village at Highland Park

Is Village at Highland Park tap water safe to drink?

EPA monitoring detected 4 contaminants in Village at Highland Park's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Village at Highland Park's water?

EPA monitoring detected Nitrate, Lead, Barium, Fluoride. The full list with the level and data source for each is above.

How many people does Village at Highland Park serve?

Village at Highland Park reports serving 50 people in Massachusetts, per its EPA record.

Has Village at Highland Park had any water quality violations?

The EPA has 19 violations on file for Village at Highland Park, of which 9 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.