← Kansas

Tap water quality report

Barton Hills Addition

EPA monitoring tested this supplier for 50 contaminants and detected 13. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

50
contaminants tested
13
detected
176
people served
19
health-based violations
Water source
Ground water
Ownership
Private
Counties served
Barton

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

19
health-based violations
142
violations on file
8
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2013-09-01 → 2013-09-30
MCL Health-based Resolved 2013-09-01 → 2013-09-30
MCL Health-based Resolved 2013-09-01 → 2013-09-30
MCL Health-based Resolved 2013-09-01 → 2013-09-30
MCL Health-based Resolved 2013-09-01 → 2013-09-30
MCL Health-based Resolved 2013-08-01 → 2013-08-31
MCL Health-based Resolved 2013-08-01 → 2013-08-31
MCL Health-based Resolved 2013-08-01 → 2013-08-31
MCL Health-based Resolved 2013-08-01 → 2013-08-31
MCL Health-based Resolved 2013-08-01 → 2013-08-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
3585 µg/L 36%
of the EPA limit 10000 µg/L
worst single sample: 3700 µg/L
64/64 SYR4 2012–2019
Copper
240 µg/L 18%
of the EPA limit 1300 µg/L
worst single sample: 300 µg/L
26/26 SYR4 2012–2018
Lead
7.44 µg/L 50%
of the EPA limit 15 µg/L
worst single sample: 12 µg/L
13/26 SYR4 2012–2018
Lead
0.0016 mg/L 11%
of the EPA limit 0.0150 mg/L
11/11 LCR 2022
Barium
87 µg/L 4.4%
of the EPA limit 2000 µg/L
9/9 SYR4 2012–2018
Fluoride
346 µg/L 8.6%
of the EPA limit 4000 µg/L
worst single sample: 350 µg/L
9/9 SYR4 2012–2018
Selenium
4.06 µg/L 8.1%
of the EPA limit 50 µg/L
worst single sample: 4.1 µg/L
9/9 SYR4 2012–2018
Arsenic
1.28 µg/L 13%
of the EPA limit 10 µg/L
worst single sample: 1.3 µg/L
5/9 SYR4 2012–2018
Carbon Tetrachloride
3.73 µg/L 75%
of the EPA limit 5 µg/L
worst single sample: 3.9 µg/L
3/40 SYR4 2013–2019
Chromium
4.48 µg/L 4.5%
of the EPA limit 100 µg/L
worst single sample: 4.5 µg/L
3/9 SYR4 2012–2018
Combined Radium (-226 And -228)
1.265 pCi/L 25%
of the EPA limit 5 pCi/L
worst single sample: 1.3 pCi/L
2/3 SYR4 2014–2017
Bromodichloromethane
0.6300 µg/L
No EPA limit set
1/6 SYR4 2013–2019
Chloroform
0.7000 µg/L
No EPA limit set
1/6 SYR4 2013–2019
37 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalAtrazineBenzeneBeryllium, TotalBromoformChlorobenzeneCadmiumDichloromethaneDibromoacetic AcidDibromochloromethaneDichloroacetic AcidEthylene DibromideEthylbenzeneMercuryMonobromoacetic AcidMonochloroacetic AcidStyreneTTHMTetrachloroethyleneThallium, TotalTolueneTotal Haloacetic Acids (HAA5)Trichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
LLOYD, JIM
Phone
620-797-3301
Email
BARTONRWD@RURALTEL.NET

Frequently asked questions about Barton Hills Addition

Is Barton Hills Addition tap water safe to drink?

EPA monitoring detected 13 contaminants in Barton Hills Addition's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Barton Hills Addition's water?

EPA monitoring detected Nitrate, Copper, Lead, Lead, Barium, and others. The full list with the level and data source for each is above.

How many people does Barton Hills Addition serve?

Barton Hills Addition reports serving 176 people in Kansas, per its EPA record.

Has Barton Hills Addition had any water quality violations?

The EPA has 142 violations on file for Barton Hills Addition, of which 19 are health-based (a contaminant limit or required treatment was breached) and 8 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.