Tap WaterIndex

← Indiana

Tap water quality report

Morocco Water Department

EPA monitoring tested this supplier for 71 contaminants and detected 15. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

71
contaminants tested
15
detected
1,200
people served
8
health-based violations
Indiana rankingsLead in IndianaPFAS in Indiana
Water source
Ground water
Ownership
Local government
Counties served
Newton

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

8
health-based violations
37
violations on file
3
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2020-07-01 → 2020-09-30
MCL Health-based Resolved 2020-07-01 → 2020-09-30
MCL Health-based Resolved 2020-07-01 → 2020-09-30
MCL Health-based Resolved 2020-07-01 → 2020-09-30
MCL Health-based Resolved 2020-04-01 → 2020-06-30
MCL Health-based Resolved 2020-04-01 → 2020-06-30
MCL Health-based Resolved 2020-04-01 → 2020-06-30
MCL Health-based Resolved 2020-04-01 → 2020-06-30
RPT Monitoring Unaddressed 2025-07-02
RPT Monitoring Unaddressed 2025-07-02

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
1627.5 µg/L 125%
of the EPA limit, at the 95th percentile of samples — 1300 µg/L
worst single sample: 2310 µg/L
86/86 SYR4 2012–2019
TTHM
93.65 µg/L 117%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 97 µg/L
28/28 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
40.3 µg/L 67%
of the EPA limit 60 µg/L
worst single sample: 51 µg/L
28/28 SYR4 2012–2019
Lead
2.2 µg/L 15%
of the EPA limit 15 µg/L
worst single sample: 4.1 µg/L
20/86 SYR4 2012–2019
Bromodichloromethane
4.84 µg/L
No EPA limit set
worst single sample: 5.2 µg/L
13/13 SYR4 2012–2017
Chloroform
18.66 µg/L
No EPA limit set
worst single sample: 21.9 µg/L
13/13 SYR4 2012–2017
Lead
0.0010 mg/L 6.7%
of the EPA limit 0.0150 mg/L
 6/6 LCR 2002
Dibromochloromethane
0.7000 µg/L
No EPA limit set
 4/13 SYR4 2012–2017
Nitrate
120 µg/L 1.2%
of the EPA limit 10000 µg/L
 4/16 SYR4 2012–2019
Xylenes, Total
1.39 µg/L 0%
of the EPA limit 10000 µg/L
worst single sample: 1.4 µg/L
3/13 SYR4 2012–2017
Antimony, Total
10.47 µg/L 175%
of the EPA limit, at the 95th percentile of samples — 6 µg/L
worst single sample: 11 µg/L
2/5 SYR4 2014–2018
Barium
91.1 µg/L 4.6%
of the EPA limit 2000 µg/L
worst single sample: 94 µg/L
2/2 SYR4 2014–2017
Fluoride
490.95 µg/L 12%
of the EPA limit 4000 µg/L
worst single sample: 511 µg/L
2/2 SYR4 2014–2017
Combined Radium (-226 And -228)
0.6600 pCi/L 13%
of the EPA limit 5 pCi/L
 1/1 SYR4 2018
Mercury
0.3000 µg/L 15%
of the EPA limit 2 µg/L
 1/2 SYR4 2014–2017
56 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DArsenicAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalBromoformChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneGlyphosateHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMethoxychlorOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneToxapheneTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
KIMBRELL, NICOLE
Phone
815-573-2018
Email
nkimbrell@townofmorocco.in.gov

Frequently asked questions about Morocco Water Department

Is Morocco Water Department tap water safe to drink?

EPA monitoring detected 15 contaminants in Morocco Water Department's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Morocco Water Department's water?

EPA monitoring detected Copper, TTHM, Total Haloacetic Acids (HAA5), Lead, Bromodichloromethane, and others. The full list with the level and data source for each is above.

How many people does Morocco Water Department serve?

Morocco Water Department reports serving 1,200 people in Indiana, per its EPA record.

Has Morocco Water Department had any water quality violations?

The EPA has 37 violations on file for Morocco Water Department, of which 8 are health-based (a contaminant limit or required treatment was breached) and 3 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.