Is Park Ridge Mhc Tap Water Safe? Quality Report

Water source: SWP
Ownership: Private
Counties served: Sangamon

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

health-based violations

violations on file

still open

Violation	Type	Status	Period
TT	Health-based	Resolved	2024-04-02
TT	Health-based	Resolved	2024-04-02
TT	Health-based	Resolved	2024-04-02
TT	Health-based	Resolved	2024-04-02
Other	Monitoring	Unaddressed	2025-07-01
MON	Monitoring	Resolved	2019-12-01 → 2019-12-31
MON	Monitoring	Resolved	2019-12-01 → 2019-12-31
MON	Monitoring	Resolved	2019-12-01 → 2019-12-31
MON	Monitoring	Resolved	2019-12-01 → 2019-12-31
MR	Monitoring	Resolved	2019-10-01 → 2019-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.

Contaminant	Level vs EPA limit	Detection rate	Source	Period
Lead	0.0 mg/L 0% of the EPA limit 0.0150 mg/L	10/10	LCR	2025
Bromodichloromethane	11.37 µg/L No EPA limit set worst single sample: 11.4 µg/L	7/7	SYR4	2013–2019
Chloroform	48.64 µg/L No EPA limit set worst single sample: 48.7 µg/L	7/7	SYR4	2013–2019
Dibromochloromethane	4.33 µg/L No EPA limit set worst single sample: 4.6 µg/L	7/7	SYR4	2013–2019
Dichloroacetic Acid	22.69 µg/L No EPA limit set worst single sample: 23.2 µg/L	7/7	SYR4	2013–2019
TTHM	60.8 µg/L 76% of the EPA limit 80 µg/L worst single sample: 61.1 µg/L	7/7	SYR4	2013–2019
Total Haloacetic Acids (HAA5)	28.54 µg/L 48% of the EPA limit 60 µg/L worst single sample: 28.6 µg/L	7/7	SYR4	2013–2019
Trichloroacetic Acid	6.68 µg/L No EPA limit set worst single sample: 7.1 µg/L	7/7	SYR4	2013–2019
Dibromoacetic Acid	1.19 µg/L No EPA limit set worst single sample: 1.2 µg/L	3/7	SYR4	2013–2019
Lead	11.3 µg/L 75% of the EPA limit 15 µg/L	1/35	SYR4	2014–2017

4 contaminants tested, none detected

BromoformCopperMonobromoacetic AcidMonochloroacetic Acid

Utility contact

Contact: MORRELL, EDWARD
Phone: 347-693-6111
Email: emorrell@usoniapartners.com

Frequently asked questions about Park Ridge Mhc

Is Park Ridge Mhc tap water safe to drink?

EPA monitoring detected 10 contaminants in Park Ridge Mhc's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Park Ridge Mhc's water?

EPA monitoring detected Lead, Bromodichloromethane, Chloroform, Dibromochloromethane, Dichloroacetic Acid, and others. The full list with the level and data source for each is above.

How many people does Park Ridge Mhc serve?

Park Ridge Mhc reports serving 116 people in Florida, per its EPA record.

Has Park Ridge Mhc had any water quality violations?

The EPA has 17 violations on file for Park Ridge Mhc, of which 4 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.