Tap WaterIndex

← Illinois

Tap water quality report

Patch Place Mhc

EPA monitoring tested this supplier for 14 contaminants and detected 8. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

14
contaminants tested
8
detected
47
people served
0
health-based violations
Illinois rankingsLead in IllinoisPFAS in Illinois
Water source
SWP
Ownership
Private
Counties served
Sangamon

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
4
violations on file
0
still open
ViolationTypeStatusPeriod
MR Monitoring Resolved 2013-07-01 → 2013-07-31
MR Monitoring Resolved 2013-07-01 → 2013-07-31
MR Monitoring Resolved 2013-07-01 → 2013-07-31
MR Monitoring Resolved 2013-07-01 → 2013-07-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Bromodichloromethane
8.785 µg/L
No EPA limit set
worst single sample: 8.8 µg/L
2/2 SYR4 2013–2014
Chloroform
43.71 µg/L
No EPA limit set
worst single sample: 43.9 µg/L
2/2 SYR4 2013–2014
Dibromochloromethane
2.795 µg/L
No EPA limit set
worst single sample: 2.8 µg/L
2/2 SYR4 2013–2014
Dichloroacetic Acid
22.365 µg/L
No EPA limit set
worst single sample: 22.6 µg/L
2/2 SYR4 2013–2014
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 2/2 LCR 2014
TTHM
54.93 µg/L 69%
of the EPA limit 80 µg/L
worst single sample: 55.1 µg/L
2/2 SYR4 2013–2014
Total Haloacetic Acids (HAA5)
26.905 µg/L 45%
of the EPA limit 60 µg/L
worst single sample: 27.1 µg/L
2/2 SYR4 2013–2014
Trichloroacetic Acid
5.26 µg/L
No EPA limit set
worst single sample: 5.3 µg/L
2/2 SYR4 2013–2014
6 contaminants tested, none detected
BromoformCopperDibromoacetic AcidLeadMonobromoacetic AcidMonochloroacetic Acid

Utility contact

Contact
EDWARDS, KADE
Phone
217-408-5750
Email
assistant@grandvalleymhc.com

Frequently asked questions about Patch Place Mhc

Is Patch Place Mhc tap water safe to drink?

EPA monitoring detected 8 contaminants in Patch Place Mhc's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Patch Place Mhc's water?

EPA monitoring detected Bromodichloromethane, Chloroform, Dibromochloromethane, Dichloroacetic Acid, Lead, and others. The full list with the level and data source for each is above.

How many people does Patch Place Mhc serve?

Patch Place Mhc reports serving 47 people in Illinois, per its EPA record.

Has Patch Place Mhc had any water quality violations?

The EPA has 4 violations on file for Patch Place Mhc, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.