← Illinois

Tap water quality report

Bloomington Township Pwd-Crestwicke

EPA monitoring tested this supplier for 14 contaminants and detected 11. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

14
contaminants tested
11
detected
900
people served
7
health-based violations
Water source
SWP
Ownership
Local government
Counties served
McLean

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

7
health-based violations
10
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 1985-07-01 → 1988-06-30
MCL Health-based Resolved 1985-07-01 → 1988-06-30
MCL Health-based Resolved 1985-07-01 → 1988-06-30
MCL Health-based Resolved 1985-07-01 → 1988-06-30
MCL Health-based Resolved 1985-07-01 → 1988-06-30
MCL Health-based Resolved 1985-07-01 → 1988-06-30
MCL Health-based Resolved 1985-07-01 → 1988-06-30
Other Monitoring Resolved 2023-07-10
Other Monitoring Resolved 2023-07-10
MR Monitoring Archived 1977-06-30 → 1981-06-29

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Bromodichloromethane
10.8 µg/L
No EPA limit set
worst single sample: 10.9 µg/L
31/31 SYR4 2012–2019
Chloroform
35.8 µg/L
No EPA limit set
worst single sample: 37 µg/L
31/31 SYR4 2012–2019
Dibromochloromethane
5.4 µg/L
No EPA limit set
worst single sample: 6.3 µg/L
31/31 SYR4 2012–2019
Dichloroacetic Acid
19.8 µg/L
No EPA limit set
worst single sample: 25.3 µg/L
31/31 SYR4 2012–2019
TTHM
46.9 µg/L 59%
of the EPA limit 80 µg/L
worst single sample: 49.1 µg/L
31/31 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
28.15 µg/L 47%
of the EPA limit 60 µg/L
worst single sample: 32.4 µg/L
31/31 SYR4 2012–2019
Trichloroacetic Acid
9.45 µg/L
No EPA limit set
worst single sample: 10.2 µg/L
31/31 SYR4 2012–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
22/22 LCR 2025
Dibromoacetic Acid
1.455 µg/L
No EPA limit set
worst single sample: 1.5 µg/L
10/31 SYR4 2012–2019
Copper
196 µg/L 15%
of the EPA limit 1300 µg/L
worst single sample: 216 µg/L
5/31 SYR4 2013–2019
Monobromoacetic Acid
1.3 µg/L
No EPA limit set
1/31 SYR4 2012–2019
3 contaminants tested, none detected
BromoformLeadMonochloroacetic Acid

Utility contact

Contact
BODE, BRAD
Phone
309-827-2893
Email
bbode@btpwd.org

Frequently asked questions about Bloomington Township Pwd-Crestwicke

Is Bloomington Township Pwd-Crestwicke tap water safe to drink?

EPA monitoring detected 11 contaminants in Bloomington Township Pwd-Crestwicke's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Bloomington Township Pwd-Crestwicke's water?

EPA monitoring detected Bromodichloromethane, Chloroform, Dibromochloromethane, Dichloroacetic Acid, TTHM, and others. The full list with the level and data source for each is above.

How many people does Bloomington Township Pwd-Crestwicke serve?

Bloomington Township Pwd-Crestwicke reports serving 900 people in Illinois, per its EPA record.

Has Bloomington Township Pwd-Crestwicke had any water quality violations?

The EPA has 10 violations on file for Bloomington Township Pwd-Crestwicke, of which 7 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.