Is Alpine Village Mhp Tap Water Safe? Quality Report

Water source: SWP
Ownership: Private
Counties served: Cook

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

health-based violations

violations on file

still open

Violation	Type	Status	Period
Other	Monitoring	Resolved	2025-04-12
Other	Monitoring	Resolved	2025-04-12
Other	Monitoring	Resolved	2025-04-12
Other	Monitoring	Resolved	2025-04-12
Other	Monitoring	Resolved	2024-07-01
Other	Monitoring	Resolved	2024-07-01
MR	Monitoring	Resolved	2024-01-01 → 2024-03-31
MR	Monitoring	Resolved	2024-01-01 → 2024-03-31
MR	Monitoring	Resolved	2024-01-01 → 2024-03-31
MR	Monitoring	Resolved	2024-01-01 → 2024-03-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.

Contaminant	Level vs EPA limit	Detection rate	Source	Period
Bromodichloromethane	9.98 µg/L No EPA limit set worst single sample: 10.7 µg/L	10/10	SYR4	2017–2019
Chloroform	11.115 µg/L No EPA limit set worst single sample: 12.6 µg/L	10/10	SYR4	2017–2019
Dibromochloromethane	5.72 µg/L No EPA limit set worst single sample: 5.9 µg/L	10/10	SYR4	2017–2019
Lead	0.0 mg/L 0% of the EPA limit 0.0150 mg/L	10/10	LCR	2025
TTHM	26.815 µg/L 34% of the EPA limit 80 µg/L worst single sample: 29.2 µg/L	10/10	SYR4	2017–2019
Total Haloacetic Acids (HAA5)	7.005 µg/L 12% of the EPA limit 60 µg/L worst single sample: 7.5 µg/L	10/10	SYR4	2017–2019
Trichloroacetic Acid	3.03 µg/L No EPA limit set worst single sample: 3.3 µg/L	10/10	SYR4	2017–2019
Dichloroacetic Acid	4 µg/L No EPA limit set worst single sample: 4.2 µg/L	9/10	SYR4	2017–2019
Copper	574.2 µg/L 44% of the EPA limit 1300 µg/L worst single sample: 622 µg/L	3/40	SYR4	2017–2019

5 contaminants tested, none detected

BromoformDibromoacetic AcidLeadMonobromoacetic AcidMonochloroacetic Acid

Utility contact

Contact: GALLEGOS, CHERYL
Phone: 602-457-2515
Email: cgallegos@inspirecommunities.com

Frequently asked questions about Alpine Village Mhp

Is Alpine Village Mhp tap water safe to drink?

EPA monitoring detected 9 contaminants in Alpine Village Mhp's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Alpine Village Mhp's water?

EPA monitoring detected Bromodichloromethane, Chloroform, Dibromochloromethane, Lead, TTHM, and others. The full list with the level and data source for each is above.

How many people does Alpine Village Mhp serve?

Alpine Village Mhp reports serving 994 people in Arizona, per its EPA record.

Has Alpine Village Mhp had any water quality violations?

The EPA has 31 violations on file for Alpine Village Mhp, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.