← Iowa

Tap water quality report

Coal Valley Water District

EPA monitoring tested this supplier for 14 contaminants and detected 11. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

14
contaminants tested
11
detected
240
people served
12
health-based violations
Water source
GWP
Ownership
Private
Counties served
Boone

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

12
health-based violations
33
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2010-08-01 → 2010-08-31
MCL Health-based Resolved 2010-08-01 → 2010-08-31
MCL Health-based Resolved 2010-08-01 → 2010-08-31
MCL Health-based Resolved 2010-08-01 → 2010-08-31
MCL Health-based Resolved 1998-07-01 → 1998-07-31
MCL Health-based Resolved 1998-07-01 → 1998-07-31
MCL Health-based Resolved 1998-07-01 → 1998-07-31
MCL Health-based Resolved 1996-10-01 → 1996-10-31
MCL Health-based Resolved 1996-10-01 → 1996-10-31
MCL Health-based Resolved 1996-10-01 → 1996-10-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the single worst sample on record — over 100% is worth reading, but is not by itself a violation. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.0080 mg/L 53%
of the EPA limit 0.0150 mg/L
14/14 LCR 2023
Copper
1390 µg/L 107%
of the EPA limit, in the worst sample — 1300 µg/L
10/10 SYR4 2014–2017
Lead
4 µg/L 27%
of the EPA limit 15 µg/L
3/10 SYR4 2014–2017
Bromodichloromethane
8.1 µg/L
No EPA limit set
2/2 SYR4 2014–2017
Bromoform
2.4 µg/L
No EPA limit set
2/2 SYR4 2014–2017
Chloroform
5.1 µg/L
No EPA limit set
2/2 SYR4 2014–2017
Dibromoacetic Acid
4 µg/L
No EPA limit set
2/2 SYR4 2014–2017
Dibromochloromethane
7.8 µg/L
No EPA limit set
2/2 SYR4 2014–2017
Dichloroacetic Acid
3 µg/L
No EPA limit set
2/2 SYR4 2014–2017
TTHM
23 µg/L 29%
of the EPA limit 80 µg/L
2/2 SYR4 2014–2017
Total Haloacetic Acids (HAA5)
6 µg/L 10%
of the EPA limit 60 µg/L
2/2 SYR4 2014–2017
3 contaminants tested, none detected
Monobromoacetic AcidMonochloroacetic AcidTrichloroacetic Acid

Utility contact

Contact
OGDEN MUNICIPAL UTILITIES
Phone
515-275-2437
Email
bcraighton@ogdenutilities.com

Frequently asked questions about Coal Valley Water District

Is Coal Valley Water District tap water safe to drink?

EPA monitoring detected 11 contaminants in Coal Valley Water District's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Coal Valley Water District's water?

EPA monitoring detected Lead, Copper, Lead, Bromodichloromethane, Bromoform, and others. The full list with the level and data source for each is above.

How many people does Coal Valley Water District serve?

Coal Valley Water District reports serving 240 people in Iowa, per its EPA record.

Has Coal Valley Water District had any water quality violations?

The EPA has 33 violations on file for Coal Valley Water District, of which 12 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.