Tap WaterIndex

← New Jersey

Tap water quality report

Parkview Mhp

EPA monitoring tested this supplier for 68 contaminants and detected 13. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

68
contaminants tested
13
detected
60
people served
3
health-based violations
New Jersey rankingsLead in New JerseyPFAS in New Jersey
Water source
Ground water
Ownership
Private
Counties served
Hillsborough

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

3
health-based violations
689
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 1994-05-01 → 1994-05-31
MCL Health-based Archived 1994-05-01 → 1994-05-31
MCL Health-based Archived 1994-05-01 → 1994-05-31
MR Monitoring Resolved 2017-01-01 → 2017-03-31
MR Monitoring Resolved 2017-01-01 → 2017-03-31
MR Monitoring Resolved 2017-01-01 → 2017-03-31
MR Monitoring Resolved 2017-01-01 → 2017-03-31
MR Monitoring Resolved 2016-01-01 → 2016-03-31
MR Monitoring Resolved 2016-01-01 → 2016-03-31
MR Monitoring Resolved 2016-01-01 → 2016-03-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
7400 µg/L 74%
of the EPA limit 10000 µg/L
worst single sample: 9900 µg/L
48/50 SYR4 2012–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 13/13 LCR 2024
TTHM
18.932 µg/L 24%
of the EPA limit 80 µg/L
worst single sample: 19.35 µg/L
5/5 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
25.7885 µg/L 43%
of the EPA limit 60 µg/L
worst single sample: 29.78 µg/L
4/5 SYR4 2012–2019
Copper
4.89 µg/L 0.4%
of the EPA limit 1300 µg/L
worst single sample: 4.9 µg/L
3/3 SYR4 2012–2018
Arsenic
0.1950 µg/L 2%
of the EPA limit 10 µg/L
worst single sample: 0.2000 µg/L
2/3 SYR4 2012–2018
Barium
3.495 µg/L 0.2%
of the EPA limit 2000 µg/L
worst single sample: 3.5 µg/L
2/3 SYR4 2012–2018
Chromium
0.8000 µg/L 0.8%
of the EPA limit 100 µg/L
 2/3 SYR4 2012–2018
Fluoride
140 µg/L 3.5%
of the EPA limit 4000 µg/L
 2/6 SYR4 2012–2018
Thallium, Total
0.2900 µg/L 14%
of the EPA limit 2 µg/L
worst single sample: 0.3000 µg/L
2/3 SYR4 2012–2018
Antimony, Total
0.2000 µg/L 3.3%
of the EPA limit 6 µg/L
 1/3 SYR4 2012–2018
Lead
0.5000 µg/L 3.3%
of the EPA limit 15 µg/L
 1/3 SYR4 2012–2018
O-Dichlorobenzene
0.8400 µg/L 0.1%
of the EPA limit 600 µg/L
 1/7 SYR4 2012–2019
55 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneGlyphosateHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
SHEILLA GUNDERMAN
Phone
813-294-8869

Frequently asked questions about Parkview Mhp

Is Parkview Mhp tap water safe to drink?

EPA monitoring detected 13 contaminants in Parkview Mhp's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Parkview Mhp's water?

EPA monitoring detected Nitrate, Lead, TTHM, Total Haloacetic Acids (HAA5), Copper, and others. The full list with the level and data source for each is above.

How many people does Parkview Mhp serve?

Parkview Mhp reports serving 60 people in New Jersey, per its EPA record.

Has Parkview Mhp had any water quality violations?

The EPA has 689 violations on file for Parkview Mhp, of which 3 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.