← Florida

Tap water quality report

Columbia County-Ellisville

EPA monitoring tested this supplier for 68 contaminants and detected 15. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

68
contaminants tested
15
detected
75
people served
16
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Columbia

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

16
health-based violations
37
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2012-10-01 → 2012-12-31
MCL Health-based Resolved 2012-07-01 → 2012-09-30
MCL Health-based Resolved 2012-07-01 → 2012-09-30
MCL Health-based Resolved 2012-04-01 → 2012-06-30
MCL Health-based Resolved 2012-04-01 → 2012-06-30
MCL Health-based Resolved 2012-04-01 → 2012-06-30
MCL Health-based Resolved 2012-04-01 → 2012-06-30
MCL Health-based Resolved 2012-04-01 → 2012-06-30
MCL Health-based Resolved 2012-04-01 → 2012-06-30
MCL Health-based Resolved 2012-04-01 → 2012-06-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
470 µg/L 4.7%
of the EPA limit 10000 µg/L
12/20 SYR4 2012–2018
TTHM
97.865 µg/L 122%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 97.9 µg/L
8/8 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
142.8 µg/L 238%
of the EPA limit, at the 95th percentile of samples — 60 µg/L
worst single sample: 144 µg/L
7/8 SYR4 2012–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
6/6 LCR 2024
Barium
15.31 µg/L 0.8%
of the EPA limit 2000 µg/L
worst single sample: 16 µg/L
3/3 SYR4 2012–2018
Nitrite
496 µg/L 50%
of the EPA limit 1000 µg/L
worst single sample: 530 µg/L
3/10 SYR4 2012–2018
Arsenic
5.705 µg/L 57%
of the EPA limit 10 µg/L
worst single sample: 5.8 µg/L
2/3 SYR4 2012–2018
Copper
76.085 µg/L 5.9%
of the EPA limit 1300 µg/L
worst single sample: 80 µg/L
2/2 SYR4 2015–2018
Cyanide
4.89 µg/L 2.4%
of the EPA limit 200 µg/L
worst single sample: 5 µg/L
2/4 SYR4 2012–2018
Chromium
10.845 µg/L 11%
of the EPA limit 100 µg/L
worst single sample: 11.4 µg/L
2/3 SYR4 2012–2018
Fluoride
370 µg/L 9.3%
of the EPA limit 4000 µg/L
2/7 SYR4 2012–2018
Bhc-Gamma
0.0071 µg/L 3.6%
of the EPA limit 0.2000 µg/L
1/5 SYR4 2012–2018
Lead
7.5 µg/L 50%
of the EPA limit 15 µg/L
1/3 SYR4 2012–2018
Selenium
2.9 µg/L 5.8%
of the EPA limit 50 µg/L
1/3 SYR4 2012–2018
Thallium, Total
10.3 µg/L 515%
of the EPA limit, at the 95th percentile of samples — 2 µg/L
1/8 SYR4 2012–2018
53 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAtrazineBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCadmiumCarbofuranCarbon TetrachlorideChlordaneDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneGlyphosateHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorOxamylPentachlorophenolPicloramSimazineStyreneTetrachloroethyleneTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
MR. SHANNON ROBERTS
Phone
386-590-0732

Frequently asked questions about Columbia County-Ellisville

Is Columbia County-Ellisville tap water safe to drink?

EPA monitoring detected 15 contaminants in Columbia County-Ellisville's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Columbia County-Ellisville's water?

EPA monitoring detected Nitrate, TTHM, Total Haloacetic Acids (HAA5), Lead, Barium, and others. The full list with the level and data source for each is above.

How many people does Columbia County-Ellisville serve?

Columbia County-Ellisville reports serving 75 people in Florida, per its EPA record.

Has Columbia County-Ellisville had any water quality violations?

The EPA has 37 violations on file for Columbia County-Ellisville, of which 16 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.