← California

Tap water quality report

Stinson Beach County Wtr Dist

EPA monitoring tested this supplier for 71 contaminants and detected 21. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

71
contaminants tested
21
detected
583
people served
4
health-based violations
Water source
Surface water
Ownership
Local government
Counties served
Marin

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

4
health-based violations
7
violations on file
0
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 1998-01-01
TT Health-based Resolved 1998-01-01
MCL Health-based Resolved 1995-06-01 → 1995-06-30
MCL Health-based Resolved 1995-06-01 → 1995-06-30
MR Monitoring Archived 2021-04-01 → 2021-06-30
MR Monitoring Resolved 1993-07-01 → 2000-04-04
MR Monitoring Resolved 1993-07-01 → 2000-04-04

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Arsenic
13.35 µg/L 134%
of the EPA limit, at the 95th percentile of samples — 10 µg/L
worst single sample: 33 µg/L
194/228 SYR4 2012–2019
Nitrate
1569.7 µg/L 16%
of the EPA limit 10000 µg/L
worst single sample: 1898.4 µg/L
64/78 SYR4 2012–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
40/40 LCR 2023
Fluoride
267 µg/L 6.7%
of the EPA limit 4000 µg/L
worst single sample: 330 µg/L
27/28 SYR4 2012–2019
Bromodichloromethane
17.5 µg/L
No EPA limit set
worst single sample: 19 µg/L
11/11 SYR4 2012–2019
Chloroform
18.5 µg/L
No EPA limit set
worst single sample: 19 µg/L
11/11 SYR4 2012–2019
Dibromochloromethane
16 µg/L
No EPA limit set
11/11 SYR4 2012–2019
TTHM
48.5 µg/L 61%
of the EPA limit 80 µg/L
worst single sample: 52 µg/L
11/11 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
32.4 µg/L 54%
of the EPA limit 60 µg/L
worst single sample: 34.2 µg/L
11/11 SYR4 2012–2019
Trichloroacetic Acid
18.95 µg/L
No EPA limit set
worst single sample: 19.3 µg/L
11/11 SYR4 2012–2019
Bromoform
4.775 µg/L
No EPA limit set
worst single sample: 5.9 µg/L
10/11 SYR4 2012–2019
Dibromoacetic Acid
5.663 µg/L
No EPA limit set
worst single sample: 5.96 µg/L
10/11 SYR4 2012–2019
Dichloroacetic Acid
11.37 µg/L
No EPA limit set
worst single sample: 12 µg/L
10/11 SYR4 2012–2019
Barium
146 µg/L 7.3%
of the EPA limit 2000 µg/L
worst single sample: 150 µg/L
3/28 SYR4 2012–2019
Monochloroacetic Acid
3.811 µg/L
No EPA limit set
worst single sample: 4.1 µg/L
3/11 SYR4 2012–2019
Antimony, Total
14.585 µg/L 243%
of the EPA limit, at the 95th percentile of samples — 6 µg/L
worst single sample: 15 µg/L
2/30 SYR4 2012–2019
Chromium
2.535 µg/L 2.5%
of the EPA limit 100 µg/L
worst single sample: 2.6 µg/L
2/28 SYR4 2012–2019
Ethylbenzene
14 µg/L 2%
of the EPA limit 700 µg/L
1/12 SYR4 2013–2019
Monobromoacetic Acid
1.03 µg/L
No EPA limit set
1/11 SYR4 2012–2019
Toluene
1.9 µg/L 0.2%
of the EPA limit 1000 µg/L
1/12 SYR4 2013–2019
Xylenes, Total
86 µg/L 0.9%
of the EPA limit 10000 µg/L
1/12 SYR4 2013–2019
50 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAsbestosAtrazineBhc-GammaBenzeneBeryllium, TotalChlorobenzeneCopperCadmiumCarbofuranCarbon TetrachlorideChlordaneDichloromethaneDalaponDinosebDiquatEthylene DibromideEndothallEndrinHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoLeadMercuryMethoxychlorNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalToxapheneTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
NELSON, KENT
Phone
415-868-1333
Email
knelson@stinsonwater.org

Frequently asked questions about Stinson Beach County Wtr Dist

Is Stinson Beach County Wtr Dist tap water safe to drink?

EPA monitoring detected 21 contaminants in Stinson Beach County Wtr Dist's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Stinson Beach County Wtr Dist's water?

EPA monitoring detected Arsenic, Nitrate, Lead, Fluoride, Bromodichloromethane, and others. The full list with the level and data source for each is above.

How many people does Stinson Beach County Wtr Dist serve?

Stinson Beach County Wtr Dist reports serving 583 people in California, per its EPA record.

Has Stinson Beach County Wtr Dist had any water quality violations?

The EPA has 7 violations on file for Stinson Beach County Wtr Dist, of which 4 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.