Tap WaterIndex

← Washington

Tap water quality report

George Lane

EPA monitoring tested this supplier for 14 contaminants and detected 8. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

14
contaminants tested
8
detected
75
people served
2
health-based violations
Washington rankingsLead in WashingtonPFAS in Washington
Water source
GWP
Ownership
Native American

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

2
health-based violations
622
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 2001-06-01 → 2001-06-30
MCL Health-based Archived 2001-01-01 → 2001-01-31
MR Monitoring Resolved 2021-10-31
MR Monitoring Resolved 2014-01-01 → 2016-12-31
MR Monitoring Resolved 2014-01-01 → 2016-12-31
MR Monitoring Resolved 2014-01-01 → 2016-12-31
MR Monitoring Resolved 2014-01-01 → 2014-12-31
MR Monitoring Resolved 2008-12-01 → 2008-12-31
MR Monitoring Resolved 2008-10-01 → 2008-12-31
Other Monitoring Resolved 2006-07-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the single worst sample on record — over 100% is worth reading, but is not by itself a violation. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.0040 mg/L 27%
of the EPA limit 0.0150 mg/L
 10/10 LCR 2024
Copper
170 µg/L 13%
of the EPA limit 1300 µg/L
 6/19 SYR4 2012–2018
Dibromochloromethane
1.5 µg/L
No EPA limit set
 4/6 SYR4 2012–2018
Lead
6 µg/L 40%
of the EPA limit 15 µg/L
 4/19 SYR4 2012–2018
TTHM
3.6 µg/L 4.5%
of the EPA limit 80 µg/L
 4/4 SYR4 2012–2018
Bromodichloromethane
1.2 µg/L
No EPA limit set
 3/6 SYR4 2012–2018
Bromoform
1.3 µg/L
No EPA limit set
 3/6 SYR4 2012–2018
Chloroform
0.8000 µg/L
No EPA limit set
 1/6 SYR4 2012–2018
6 contaminants tested, none detected
Dibromoacetic AcidDichloroacetic AcidMonobromoacetic AcidMonochloroacetic AcidTotal Haloacetic Acids (HAA5)Trichloroacetic Acid

Utility contact

Contact
OLD COYOTE, JAMES
Phone
360-394-8506
Email
JCOYOTE@SUQUAMISH.NSN.US

Frequently asked questions about George Lane

Is George Lane tap water safe to drink?

EPA monitoring detected 8 contaminants in George Lane's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in George Lane's water?

EPA monitoring detected Lead, Copper, Dibromochloromethane, Lead, TTHM, and others. The full list with the level and data source for each is above.

How many people does George Lane serve?

George Lane reports serving 75 people in Washington, per its EPA record.

Has George Lane had any water quality violations?

The EPA has 622 violations on file for George Lane, of which 2 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.