Tap WaterIndex

← North Carolina

Tap water quality report

Kenansville, NC

EPA monitoring detected 21 contaminants across the 2 water suppliers serving Kenansville. A detection doesn't automatically mean the water is unsafe — see the highest level found for each below, with its EPA source and period.

2
water suppliers
19,418
people served
21
contaminants found
North Carolina rankings Lead in North Carolina PFAS in North Carolina

What was found in Kenansville's water

The highest level seen across the city's suppliers, the EPA limit for each, and where the figure comes from.

ContaminantLevel vs EPA limitSuppliersSource
Nitrate
2186 µg/L 22%
of the EPA limit 10000 µg/L
 1/2 SYR4
Nitrate-Nitrite
2186 µg/L 22%
of the EPA limit 10000 µg/L
 1/2 SYR4
Copper
798.8 µg/L 61%
of the EPA limit 1300 µg/L
 2/2 SYR4
Fluoride
570 µg/L 14%
of the EPA limit 4000 µg/L
 2/2 SYR4
TTHM
60 µg/L 75%
of the EPA limit 80 µg/L
 2/2 SYR4
Chloroform
41.97 µg/L
No EPA limit set
 2/2 SYR4
Lead
37 µg/L 247%
of the EPA limit, in the worst sample — 15 µg/L
 2/2 SYR4
Total Haloacetic Acids (HAA5)
31 µg/L 52%
of the EPA limit 60 µg/L
 2/2 SYR4
Dichloroacetic Acid
15 µg/L
No EPA limit set
 1/2 SYR4
Trichloroacetic Acid
14 µg/L
No EPA limit set
 2/2 SYR4
Bromodichloromethane
11.38 µg/L
No EPA limit set
 2/2 SYR4
Dibromochloromethane
5.868 µg/L
No EPA limit set
 2/2 SYR4
Bromoform
3.148 µg/L
No EPA limit set
 1/2 SYR4
Xylenes, Total
2.1 µg/L 0%
of the EPA limit 10000 µg/L
 1/2 SYR4
Monochloroacetic Acid
2 µg/L
No EPA limit set
 1/2 SYR4
Dibromoacetic Acid
1 µg/L
No EPA limit set
 2/2 SYR4
Monobromoacetic Acid
1 µg/L
No EPA limit set
 1/2 SYR4
Thallium, Total
1 µg/L 50%
of the EPA limit 2 µg/L
 1/2 SYR4
Combined Radium (-226 And -228)
0.9000 pCi/L 18%
of the EPA limit 5 pCi/L
 1/2 SYR4
Heptachlor
0.0645 µg/L 16%
of the EPA limit 0.4000 µg/L
 1/2 SYR4
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 2/2 LCR
Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the single worst sample on record — over 100% is worth reading, but is not by itself a violation. Formal violations are listed separately. These are the utilities' own EPA-reported results, not a city-wide average. A detection means the lab measured the substance — it isn't the same as exceeding a legal limit. Hover a source tag to see the EPA program and years behind each figure.

Water suppliers serving Kenansville

SupplierPopulation served
DUPLIN COUNTY WATER SYSTEM 18,542
KENANSVILLE, TOWN OF 876

Frequently asked questions about Kenansville tap water

Is Kenansville tap water safe to drink?

EPA testing detected 21 contaminants in the water serving Kenansville. A detection isn't the same as a violation — most detected levels are within federal limits. Check the level and source for each contaminant above, and your utility's annual Consumer Confidence Report for the official compliance status.

How many water suppliers serve Kenansville?

2 public water suppliers report drinking-water monitoring for Kenansville, North Carolina to the EPA. Each is listed above with its population served.

What contaminants are in Kenansville's water?

The contaminants EPA monitoring detected in Kenansville include Nitrate, Nitrate-Nitrite, Copper, Fluoride, TTHM. The full list, with the highest level found and the data source, is in the table above.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.